This is the display signal circuit of the television camera.
Disconnect the S5 inner rear view mirror assembly connector.
Disconnect the Y1 rear television camera assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| S5-14 (CB+) - Y1-4 (CB+) | Always | Below 1 Ω |
| S5-13 (CGND) - Y1-3 (CGND) | Always | Below 1 Ω |
| S5-7 (CV+) - Y1-2 (CV+) | Always | Below 1 Ω |
| S5-6 (CV-) - Y1-1 (CV-) | Always | Below 1 Ω |
| S5-14 (CB+) - Body ground | Always | 10 kΩ or higher |
| S5-13 (CGND) - Body ground | Always | 10 kΩ or higher |
| S5-7 (CV+) - Body ground | Always | 10 kΩ or higher |
| S5-6 (CV-) - Body ground | Always | 10 kΩ or higher |
OK
NG
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| S5-14 (CB+) - S5-13 (CGND) | Ignition switch ON, shift lever in R | 5.5 to 7.05 V |
| *a | Component with harness connected
(Inner Rear View Mirror Assembly) |
OK
NG
Using an oscilloscope, check the waveform.
| *a | Component with wire harness connected
(Inner Rear View Mirror Assembly) |
- | - |
| Item | Content |
|---|---|
| Tester Connection | S5-7 (CV+) - S5-6 (CV-) |
| Tool Setting | 0.2 V/DIV., 50 μs/DIV. |
| Condition | ·
Ignition switch ON, shift lever in R*1 ·
Ignition switch ON, shift lever in R, screen blacked out by covering camera lens*2 |
Waveform is as shown in illustration.
OK
(See pageAudio / Visual / Telematics>PARK ASSIST / MONITORING>REAR VIEW MONITOR SYSTEM>PROBLEM SYMPTOMS TABLE)
NG