This is the power source circuit of the inner rear view mirror assembly.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the S5 inner rear view mirror assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| S5-1 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| S5-2 (E) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector
(to Inner Rear View Mirror Assembly) |
OK
(See pageAudio / Visual / Telematics>PARK ASSIST / MONITORING>REAR VIEW MONITOR SYSTEM>PROBLEM SYMPTOMS TABLE)
NG