Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM › from 2013.08
RM1440E _56 Audio / Visual / Telematics _056151 PARK ASSIST / MONITORING _0274043 TOYOTA PARKING ASSIST-SENSOR SYSTEM J

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM  Indicator Circuit  


DESCRIPTION

The warning indicator lights are installed in the combination meter assembly.

WIRING DIAGRAM

E282889E03
5.833,1.219 6.104,1.531 0.271,0.313 10 false L1 5.573,1.104 5.844,1.417 0.271,0.313 10 false 28 5.833,1.656 6.104,1.969 0.271,0.313 10 false L2 5.583,1.573 5.854,1.885 0.271,0.313 10 false 29 5.813,2.125 6.083,2.438 0.271,0.313 10 false L3 5.573,2.031 5.844,2.344 0.271,0.313 10 false 30 3.031,2.313 3.365,2.625 0.333,0.313 10 false IG+ 2.781,2.208 3.052,2.521 0.271,0.313 10 false 17 5.813,2.583 6.083,2.896 0.271,0.313 10 false L4 5.625,2.51 5.896,2.823 0.271,0.313 10 false 9 5.813,3.052 6.083,3.365 0.271,0.313 10 false L5 5.573,2.958 5.844,3.271 0.271,0.313 10 false 26 5.823,3.521 6.146,3.729 0.323,0.208 10 false L10 3.729,1.25 3.99,1.458 0.26,0.208 10 false RR 3.75,1.677 4.01,1.906 0.26,0.229 10 false RL 3.729,2.167 4,2.365 0.271,0.198 10 false BK 3.729,2.625 4,2.833 0.271,0.208 10 false FR 3.76,3.094 3.99,3.281 0.229,0.188 10 false FL 3.74,3.563 4.094,3.75 0.354,0.188 10 false OP 5.583,3.396 5.854,3.708 0.271,0.313 10 false 31 4.031,1.104 4.302,1.417 0.271,0.313 10 false 7 4.01,1.583 4.281,1.896 0.271,0.313 10 false 12 4.01,2.031 4.281,2.344 0.271,0.313 10 false 18 4.01,2.5 4.281,2.813 0.271,0.313 10 false 35 4.01,2.958 4.281,3.271 0.271,0.313 10 false 32 4.01,3.427 4.281,3.74 0.271,0.313 10 false 31 0.208,2.323 1.156,2.531 0.948,0.208 10 false from IG2 Relay 1.677,2.521 2.313,2.781 0.635,0.26 10 false GAUGE 2.583,4.281 4.469,4.51 1.885,0.229 10 false Combination Meter Assembly 2.594,4.125 3,4.354 0.406,0.229 10 false F14 5.615,4.219 6.906,4.604 1.292,0.385 10 false Clearance Warning ECU Assembly 5.635,4.073 6.042,4.302 0.406,0.229 10 false F78

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - BATTERY)
a.
U150511E02
2.323,1.281 2.875,0.781 true 0.813,0.5 1.073,0.656 0.26,0.156 10 false F14 2.938,0.625 3.26,0.896 0.323,0.271 10 false IG+ 0.208,0.115 0.385,0.271 0.177,0.156 10 false *a

Disconnect the F14 combination meter assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
F14-17 (IG+) - Body ground Ignition switch ON 11 to 14 V


Text in Illustration
*a Front view of wire harness connector
(to Combination Meter Assembly)



OK

2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - COMBINATION METER ASSEMBLY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - COMBINATION METER ASSEMBLY)
a.

Disconnect the F78 clearance warning ECU assembly connector.


b.

Disconnect the F14 combination meter assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F78-9 (L4) - F14-35 (FR) Always Below 1 Ω
F78-26 (L5) - F14-32 (FL) Always Below 1 Ω
F78-28 (L1) - F14-7 (RR) Always Below 1 Ω
F78-29 (L2) - F14-12 (RL) Always Below 1 Ω
F78-30 (L3) - F14-18 (BK) Always Below 1 Ω
F78-31 (L10) - F14-31 (OP) Always Below 1 Ω
F78-9 (L4) - Body ground Always 10 kΩ or higher
F78-26 (L5) - Body ground Always 10 kΩ or higher
F78-28 (L1) - Body ground Always 10 kΩ or higher
F78-29 (L2) - Body ground Always 10 kΩ or higher
F78-30 (L3) - Body ground Always 10 kΩ or higher
F78-31 (L10) - Body ground Always 10 kΩ or higher




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR