Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM › from 2013.08
RM1440E _56 Audio / Visual / Telematics _056151 PARK ASSIST / MONITORING _0274043 TOYOTA PARKING ASSIST-SENSOR SYSTEM J

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM  Taillight Relay Circuit  


DESCRIPTION

This is the power source circuit of the clearance warning ECU assembly.

WIRING DIAGRAM

E200013E04
5.219,1.583 5.438,1.781 0.219,0.198 10 false TL 5.281,2.365 5.656,2.542 0.375,0.177 10 false F78 4.958,1.49 5.156,1.667 0.198,0.177 10 false 24 5.271,2.542 6.813,2.938 1.542,0.396 10 false Clearance Warning ECU Assembly 0.646,1.583 1.646,1.781 1,0.198 10 false from TAIL Relay 2.604,1.76 3.219,2 0.615,0.24 10 false PANEL

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK TAILLIGHT
a.

Turn the light control switch to the TAIL position.


b.

Check that the taillight turns on.

OK:

Taillight turns on.




OK

2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - BATTERY)

NG

2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - BATTERY)
a.
U181083E02
1.094,1.344 1.354,1.802 true 0.115,0.042 0.302,0.198 0.188,0.156 10 false *a 1.635,0.302 2.031,0.563 0.396,0.26 10 false F78 1.385,1.813 1.573,2.01 0.188,0.198 10 false TL

Disconnect the F78 clearance warning ECU assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
F78-24 (TL) - Body ground Ignition switch ON, light control switch TAIL 11 to 14 V
Ignition switch ON, light control switch not TAIL Below 1 V


Text in Illustration
*a Front view of wire harness connector
(to clearance warning ECU assembly)



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR