Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › CLEARANCE SONAR MAIN SWITCH › from 2013.08
RM1440E _56 Audio / Visual / Telematics _056151 PARK ASSIST / MONITORING _0274047 CLEARANCE SONAR MAIN SWITCH G

PARK ASSIST / MONITORING  CLEARANCE SONAR MAIN SWITCH  INSPECTION  


PROCEDURE

Hide 84490A 1.INSPECT BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY

E197682E13
2,1.26 2.271,1.646 2.271,1.646 2.458,1.646 true 1.792,1.26 2.219,1.865 2.219,1.865 2.458,1.865 true 1.469,1.26 1.031,1.865 1.031,1.865 0.813,1.865 true 1.281,1.26 1,1.646 1,1.646 0.813,1.646 true 1.615,1.271 1.615,1.75 true 2.469,1.563 2.823,1.708 0.354,0.146 10 false ECU 2.469,1.781 2.76,1.927 0.292,0.146 10 false ILL- 1.427,1.781 1.74,1.948 0.313,0.167 10 false ILL+ 0.677,1.563 0.792,1.729 0.115,0.167 10 false E 0.594,1.771 0.781,1.938 0.188,0.167 10 false IG 0.448,0.167 0.625,0.333 0.177,0.167 10 false *a

a.

Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
3 (ECU) - 6 (IG) Sonar switch off 10 kΩ or higher
Sonar switch on Below 1 Ω


If the result is not as specified, replace the back sonar or clearance sonar switch assembly.



b.

Apply battery voltage to the connector and check the LED illumination condition.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 3 (ECU)
Battery negative (-) → Terminal 7 (E)
LED illuminates
Battery positive (+) → Terminal 5 (ILL+)
Battery negative (-) → Terminal 4 (ILL-)
LED illuminates

Text in Illustration
*a Component without harness connected
(Back Sonar or Clearance Sonar Switch Assembly)


If the result is not as specified, replace the back sonar or clearance sonar switch assembly.