Home › Power Source / Network › NETWORKING › LIN COMMUNICATION SYSTEM
RM1440E _57 Power Source / Network _056154 NETWORKING _0274052 LIN COMMUNICATION SYSTEM D

NETWORKING  LIN COMMUNICATION SYSTEM  SYSTEM DESCRIPTION  


LIN COMMUNICATION SYSTEM DESCRIPTION


The LIN communication system is used for communication between the components in the tables below. If communication cannot be performed through LIN communication because of a break in the communication lines or some other reason, the master control ECU of the relevant system stores DTCs. Refer to the table below about the communication bus lines and connected components.

HINT:
·

Each component has a fail-safe function which activates to maintain the minimum performance of the system and protect the system.

·

In the following table, "○" indicates that the function applies, and "-" indicates that it does not.



Door Bus Lines
Component Master Control LIN Communication DTC Output Function
Main body ECU (multiplex network body ECU) ○ ○
Multiplex network master switch assembly - -
Front power window regulator motor assembly LH - -
Front power window regulator motor assembly RH - -
Rear power window regulator motor assembly LH - -
Rear power window regulator motor assembly RH - -
Sliding roof drive gear sub-assembly* - -
Multiplex network door ECU (back door P/W) - -

*: w/ Sliding Roof System


Air Conditioning Bus Lines
Component Master Control LIN Communication DTC Output Function
Air conditioning amplifier assembly ○ -
Heater control assembly - -

Sub-LIN Bus Lines
Component Master Control LIN Communication DTC Output Function
Multiplex network door ECU (back door P/W) ○ ○
Back door power window regulator motor assembly - -