Home › Power Source / Network › NETWORKING › LIN COMMUNICATION SYSTEM
RM1440E _57 Power Source / Network _056154 NETWORKING _0274052 LIN COMMUNICATION SYSTEM U

NETWORKING  LIN COMMUNICATION SYSTEM  DATA LIST / ACTIVE TEST  


READ DATA LIST


HINT:

Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / Main Body / Data List.


e.

According to the display on the intelligent tester, read the Data List.

Main Body
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Communication D-Door Motor Connection status between front power window regulator motor assembly LH and main body ECU (multiplex network body ECU) / OK or STOP OK: Connection
STOP: No connection
When there is a malfunction, a DTC is stored.
Communication P-Door Motor Connection status between front power window regulator motor assembly RH and main body ECU (multiplex network body ECU) / OK or STOP OK: Connection
STOP: No connection
When there is a malfunction, a DTC is stored.
Communication RR-Door Motor Connection status between rear power window regulator motor assembly RH and main body ECU (multiplex network body ECU) / OK or STOP OK: Connection
STOP: No connection
When there is a malfunction, a DTC is stored.
Communication RL-Door Motor Connection status between rear power window regulator motor assembly LH and main body ECU (multiplex network body ECU) / OK or STOP OK: Connection
STOP: No connection
When there is a malfunction, a DTC is stored.
Communication Slide Roof* Connection status between sliding roof drive gear sub-assembly and main body ECU (multiplex network body ECU) / OK or STOP OK: Connection
STOP: No connection
When there is a malfunction, a DTC is stored.
Communication Master SW Connection status between multiplex network master switch assembly and main body ECU (multiplex network body ECU) / OK or STOP OK: Connection
STOP: No connection
When there is a malfunction, a DTC is stored.
Number of Trouble Codes Number of trouble codes / Min.: 0, Max.: 255 Number of stored DTCs displayed -

*: w/ Sliding Roof System