Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM › 2009.08–2013.08
RM1440E _57 Power Source / Network _056154 NETWORKING _0274053 CAN COMMUNICATION SYSTEM D

NETWORKING  CAN COMMUNICATION SYSTEM  DIAGNOSIS SYSTEM  


BUS CHECK (COMMUNICATION MALFUNCTION ECU)


Only CAN communication system DTCs for each ECU can be output to the intelligent tester.

a.
C128170

Select "Bus Check" from the "System Select" screen on the intelligent tester.


b.
C128171

Select "Communication Malfunction DTC" from the "Bus Check" screen, and then select "Enter".


c.
C128172

Select the system of the DTC to be checked and select "Details".


d.
C128173

CAN communication system DTCs are output.



BUS CHECK (COMMUNICATION BUS CHECK)


HINT:

The ECUs and sensors that are properly connected to the CAN communication system can be displayed using the intelligent tester.


a.
C128171

Select "Communication Bus Check" from the "Bus Check" screen.


b.

The screen displays the ECUs and sensors that are properly connected to the CAN communication system.

HINT:
·

If any properly connected ECUs or sensors are not displayed, there is a communication stop in the system (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>PROBLEM SYMPTOMS TABLE).

·
C197127

The default item displayed in the combo box is "ALL". When checking the ECUs (sensors) connected to each bus, pull down the combo box and select the bus to be checked from the drop-down list. The drop-down list displays "ALL", "V Bus" and the names of the remaining buses.

Combo Box Display Content
ALL All ECUs (sensors) connected to the CAN bus
V Bus ECUs (sensors) connected to the V Bus
Bus Name ECUs (sensors) connected to the selected bus

·

The connection status (shown below) is indicated by the background color displayed behind the system name.

ECU (Sensor) on V Bus
Background Color Connection Status
White Detected normally
Yellow Could not be detected in the past, but is currently detected
Red Detected in the past, but cannot be detected now
Not displayed Has never been detected

ECU (Sensor) with no Data Monitor History
Background Color Connection Status
White Detected normally
Yellow Could not be detected in the past, but is currently detected
Red Detected in the past, but cannot be detected now
Not displayed Has never been detected

ECU (Sensor) with Data Monitor History
Background Color Connection Status
White Detected normally
Yellow Could not be detected in the past, but is currently detected
Red Detected in the past, but cannot be detected now
Red Has never been detected but has connection history
Not displayed Has never been detected and has no connection history




c.
C128179

"There is no system connected the communication bus." is displayed if there are no ECUs or sensors connected to the CAN bus.



CHECK INSTALLED SYSTEMS (ECUS AND SENSORS) THAT USE CAN COMMUNICATION


a.

Systems (ECUs and sensors) that use CAN communication vary depending on the optional settings of the vehicle. Check which systems (ECUs and sensors) are installed on the vehicle.

ECU/Sensor Name Tester Display Installed on
ECM Engine All vehicles
Master cylinder solenoid (skid control ECU) ABS/VSC/TRC All vehicles
Yaw rate sensor assembly Yaw Rate / Deceleration Sensor All vehicles
Spiral cable sub-assembly (steering angle sensor) Steering Angle Sensor All vehicles
Power steering ECU assembly PPS All vehicles
Air conditioning amplifier assembly Air Conditioner All vehicles
Center airbag sensor assembly SRS Airbag All vehicles
Main body ECU (multiplex network body ECU) Main Body All vehicles
Combination meter assembly Combination Meter All vehicles
Four wheel drive control ECU Four Wheel Drive Control Vehicles for 4WD



DTC TABLE BY ECU


HINT:
·

In the CAN communication system, CAN communication system DTCs output from an ECU can be output by using the intelligent tester.

·

If CAN communication system DTCs are output, the trouble cannot be determined solely from the DTCs. Perform troubleshooting according to "How to Proceed with Troubleshooting".



a.

MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

HINT:

DTC communication uses the CAN communication system.


DTC Code Detection Item
U0100 Lost Communication with ECM/PCM "A"
U0101 Lost Communication with TCM
U0151 Lost Communication with Restraints Control Module
U0155 Lost Communication with Instrument Panel Cluster (IPC) Control Module
U0164 Lost Communication With HVAC Control Module


b.

MASTER CYLINDER SOLENOID (SKID CONTROL ECU)

HINT:

DTC communication uses the CAN communication system.


DTC Code Detection Item
U0073 Control Module Communication Bus OFF
U0100 Lost Communication with ECM / PCM "A"
U0114 Lost Communication with 4WD Control Module
U0123 Lost Communication with Yaw Rate Sensor Module
U0124 Lost Communication with Lateral Acceleration Sensor Module
U0126 Lost Communication with Steering Angle Sensor Module


c.

POWER STEERING ECU ASSEMBLY

HINT:

DTC communication uses the CAN communication system.


DTC Code Detection Item
U0073 Control Module Communication Bus OFF


d.

ECM

HINT:

The ECM is connected to the CAN communication system but CAN communication DTCs are not stored.



e.

COMBINATION METER ASSEMBLY

HINT:

DTC communication uses the CAN communication system.


DTC Code Detection Item
U0100 Lost Communication with ECM/PCM "A"
U0129 Lost Communication with Brake System Control Module
U0131 Lost Communication with Power Steering Control Module
U0151 Lost Communication with Restraints Control Module


f.

CENTER AIRBAG SENSOR ASSEMBLY

HINT:

The center airbag sensor assembly is connected to the CAN communication system but CAN communication DTCs are not stored.



g.

AIR CONDITIONING AMPLIFIER ASSEMBLY

HINT:

DTC communication uses the CAN communication system.


DTC Code Detection Item
U0100 Lost Communication with ECM/PCM "A"
U0142 Lost Communication with Body Control Module "B"
U0155 Lost Communication with Instrument Panel Cluster (IPC) Control Module


h.

YAW RATE SENSOR ASSEMBLY

HINT:

The yaw rate sensor assembly is connected to the CAN communication system but CAN communication DTCs are not stored.



i.

SPIRAL CABLE SUB-ASSEMBLY (STEERING ANGLE SENSOR)

HINT:

The spiral cable sub-assembly (steering angle sensor) is connected to the CAN communication system but CAN communication DTCs are not stored.



j.

FOUR WHEEL DRIVE CONTROL ECU

For vehicles with four wheel drive.

HINT:

The four wheel drive control ECU is connected to the CAN communication system but CAN communication DTCs are not stored.




DTC COMBINATION TABLE


HINT:
·

○: Stored.

·

X: When one side of the branch wire is open, storage may occur.

·

*1: Only stored when communication recovery occurs. During a communication stop it, cannot be stored.

·

*2: Only output while a malfunction is present and the ignition switch is ON.



V1 Bus Vol.1
Output from Output DTC Detection Item Detected Communication Stop Mode
V1 Bus
Main Body ECU Communication Stop Mode ECM Communication Stop Mode Brake Actuator (Skid Control ECU) Communication Stop Mode Yaw Rate Sensor Communication Stop Mode Steering Angle Sensor Communication Stop Mode
Main body ECU (multiplex network body ECU) U0100 Lost Communication with ECM/PCM "A" ○*1 ○ X X X
U0101 Lost Communication with TCM ○*1 ○ X X X
U0151 Lost Communication with Restraints Control Module ○*1 X X X X
U0155 Lost Communication with Instrument Panel Cluster (IPC) Control Module ○*1 X X X X
U0164 Lost Communication With HVAC Control Module ○*1 X X X X
Master cylinder solenoid (skid control ECU) U0073*2 Control Module Communication Bus Off X X ○*1 X X
U0100*2 Lost Communication with ECM / PCM "A" X X ○*1 X X
U0114*2 Lost Communication with 4WD Control Module X X ○*1 X X
U0123*2 Lost Communication with Yaw Rate Sensor Module X X ○*1 ○ X
U0124*2 Lost Communication with Lateral Acceleration Sensor Module X X ○*1 ○ X
U0126*2 Lost Communication with Steering Angle Sensor Module X X ○*1 X ○
Power steering ECU assembly U0073 Control Module Communication Bus Off X X X X X
Combination meter assembly U0100 Lost Communication with ECM/PCM "A" X ○ X X X
U0129 Lost Communication with Brake System Control Module X X ○ X X
U0131 Lost Communication with Power Steering Control Module X X X X X
U0151 Lost Communication with Restraints Control Module X X X X X
Air conditioning amplifier assembly U0100 Lost Communication with ECM/PCM "A" X ○ X X X
U0142 Lost Communication with Body Control Module "B" ○ X X X X
U0155 Lost Communication with Instrument Panel Cluster (IPC) Control Module X X X X X

V1 Bus Vol.2
Output from Output DTC Detection Item Detected Communication Stop Mode
V1 Bus
Power Steering ECU Communication Stop Mode Center Airbag Sensor Communication Stop Mode Combination Meter ECU Communication Stop Mode 4WD Control ECU Communication Stop Mode Air Conditioning Amplifier Communication Stop Mode
Main body ECU (multiplex network body ECU) U0100 Lost Communication with ECM/PCM "A" X X X X X
U0101 Lost Communication with TCM X X X X X
U0151 Lost Communication with Restraints Control Module X ○ X X X
U0155 Lost Communication with Instrument Panel Cluster (IPC) Control Module X X ○ X X
U0164 Lost Communication With HVAC Control Module X X X X ○
Master cylinder solenoid (skid control ECU) U0073*2 Control Module Communication Bus Off X X X X X
U0100*2 Lost Communication with ECM / PCM "A" X X X X X
U01114*2 Lost Communication with 4WD Control Module X X X ○ X
U0123*2 Lost Communication with Yaw Rate Sensor Module X X X X X
U0124*2 Lost Communication with Lateral Acceleration Sensor Module X X X X X
U0126*2 Lost Communication with Steering Angle Sensor Module X X X X X
Power steering ECU assembly U0073 Control Module Communication Bus Off ○*1 X X X X
Combination meter assembly U0100 Lost Communication with ECM/PCM "A" X X ○*1 X X
U0129 Lost Communication with Brake System Control Module X X ○*1 X X
U0131 Lost Communication with Power Steering Control Module ○ X ○*1 X X
U0151 Lost Communication with Restraints Control Module X ○ ○*1 X X
Air conditioning amplifier assembly U0100 Lost Communication with ECM/PCM "A" X X X X X
U0142 Lost Communication with Body Control Module "B" X X X X X
U0155 Lost Communication with Instrument Panel Cluster (IPC) Control Module X X ○ X X