Home › Vehicle Interior › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM
RM1440E _58 Vehicle Interior _056155 DOOR LOCK _0274054 POWER DOOR LOCK CONTROL SYSTEM U

DOOR LOCK  POWER DOOR LOCK CONTROL SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


HINT:

Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / (desired system) / Data List.


e.

According to the display on the intelligent tester, read the Data List.

Main Body
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
RR Door Courtesy SW Rear door courtesy light switch RH signal / ON or OFF ON: Rear door RH open
OFF: Rear door RH closed
-
RL Door Courtesy SW Rear door courtesy light switch LH signal / ON or OFF ON: Rear door LH open
OFF: Rear door LH closed
-
Back Door Open Back door lock position status / Permit or Prohibit Permit: Back door unlocked
Prohibit: Back door locked
-
Door Lock SW-Lock Door control switch lock signal / ON or OFF ON: Lock side of door control switch pushed
OFF: Lock side of door control switch not pushed
-
Door Lock SW-Unlock Door control switch unlock signal / ON or OFF ON: Unlock side of door control switch pushed
OFF: Unlock side of door control switch not pushed
-
Door Key SW-Lock Driver side door key-linked switch lock signal / ON or OFF ON: Driver side door key cylinder turned to lock position
OFF: Driver side door key cylinder not turned to lock position
-
D Door Key SW-UL Driver side door key-linked switch unlock signal / ON or OFF ON: Driver side door key cylinder turned to unlock position
OFF: Driver side door key cylinder not turned to unlock position
-
FR Door Lock Pos Front door lock position switch RH signal / LOCK or UNLOCK LOCK: Front door RH locked
UNLOCK: Front door RH unlocked
-
FR Door Courtesy Front door courtesy light switch RH signal / ON or OFF ON: Front door RH closed
OFF: Front door RH open
-
FL Door Lock Pos Front door lock position switch LH signal / LOCK or UNLOCK LOCK: Front door LH locked
UNLOCK: Front door LH unlocked
-
FL Door Courtesy Front door courtesy light switch LH signal / ON or OFF ON: Front door LH closed
OFF: Front door LH open
-
RR-Door Lock Pos SW Rear door lock position switch RH signal / ON or OFF ON: Rear door RH unlocked
OFF: Rear door RH locked
-
RL-Door Lock Pos SW Rear door lock position switch LH signal / ON or OFF ON: Rear door LH unlocked
OFF: Rear door LH locked
-

Master Switch
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Door Lock Switch Status Driver side door control switch lock signal / ON or OFF ON: Lock side of door control switch pushed
OFF: Lock side of door control switch not pushed
-
Door Unlock Switch Status Driver side door control switch unlock signal / ON or OFF ON: Unlock side of door control switch pushed
OFF: Unlock side of door control switch not pushed
-

Back Door P/W
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Key Switch Operation Locked Tail gate control switch signal / ON or OFF ON: Back door key cylinder turned to lock position
OFF: Back door key cylinder not turned
-
Key Switch Operation Unlocked Tail gate control switch signal / ON or OFF ON: Back door key cylinder turned to unlock position
OFF: Back door key cylinder not turned
-
Wiper Retracted Position Rear wiper retracting switch signal / ON or OFF ON: Rear wiper in retracted position
OFF: Rear wiper in other position
-
Wiper Reverse Position Rear wiper reverse position switch signal / ON or OFF ON: Rear wiper in reverse position
OFF: Rear wiper in other position
-
Back Door Courtesy Switch Back door courtesy switch signal / ON or OFF ON: Back door open
OFF: Back door closed
-
Back Door Handle Switch Back door opener switch signal / ON or OFF ON: Back door opener switch pushed
OFF: Back door opener switch not pushed
-
Back Door P/W Status Back door power window position / Open or Close Open: Back door window open
Close: Back door window closed
-
Number of Trouble Codes Number of trouble codes / Min.: 0, Max.: 255 Number of DTCs stored -



ACTIVE TEST


HINT:

Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / Main Body / Active Test.


e.

According to the display on the intelligent tester, perform the Active Test.

Main Body
Tester Display Test Part Control Range Diagnostic Note
Door Lock Operate door lock motor Unlock/Lock/OFF -
D-Door Unlock Operate driver side door lock motor ON/OFF -
Trunk and Back-Door Open Operate back door lock motor ON/OFF -