Home › Vehicle Interior › DOOR LOCK › TRANSMITTER BATTERY
RM1440E _58 Vehicle Interior _056155 DOOR LOCK _0274055 TRANSMITTER BATTERY A

DOOR LOCK  TRANSMITTER BATTERY  REPLACEMENT  


CAUTION / NOTICE / HINT

NOTICE:

Take extra care when handling these precision electronic components.


PROCEDURE

Hide 89751A 1.REMOVE TRANSMITTER HOUSING COVER

a.
U122533E04
1.24,1.01 1.646,1.458 1.646,1.458 1.854,1.458 false 1.885,1.385 2.583,1.729 0.698,0.344 10 false *1

Twist a screwdriver in the direction of the arrow in the illustration and remove the transmitter housing cover.

NOTICE:

Do not forcibly pry open the cover.


HINT:

Tape the screwdriver tip before use.


Text in Illustration
*1 Protective Tape


Hide 89071B 2.REMOVE DOOR CONTROL TRANSMITTER MODULE

a.
B137124E06
1.667,0.979 1.104,0.844 1.104,0.844 0.854,0.844 false 0.635,0.76 0.833,0.958 0.198,0.198 10 false *1

Using a precision screwdriver, remove the door control transmitter module.

HINT:

Tape the screwdriver tip before use.


Text in Illustration
*1 Protective Tape


Hide 89745A 3.REMOVE TRANSMITTER BATTERY

a.
B102246

Twist a coin in the direction of the arrow in the illustration and remove the transmitter battery cover.


b.
B102247

Remove the battery (lithium battery: CR2016).

NOTICE:
·

Do not push the terminals with your finger.

·

Do not forcibly pry up the battery. The terminals may become damaged.

·

Do not touch the battery with wet hands. Water may cause rust.

·

Do not touch or move any components inside the transmitter. The transmitter may cease to work.




Hide 89745A 4.INSTALL TRANSMITTER BATTERY

a.
B102768

Install a new battery (lithium battery: CR2016) with the positive (+) side facing upward as shown in the illustration.

NOTICE:
·

Be careful not to bend the transmitter battery electrode during insertion.

·

Keep the transmitter cover interior free of dust and oil.




b.

Install the cover.


Hide 89071B 5.INSTALL DOOR CONTROL TRANSMITTER MODULE

a.

Install the door control transmitter module.


Hide 89751A 6.INSTALL TRANSMITTER HOUSING COVER

a.

Install the transmitter housing cover to the transmitter housing case.


b.

Check that the transmitter LED illuminates 3 times when a switch is pressed 3 times.