Take extra care when handling these precision electronic components.
89751A
1.REMOVE TRANSMITTER HOUSING COVER
Take extra care when handling these precision electronic components.
Twist a screwdriver in the direction of the arrow in the illustration and open the transmitter housing cover.
Do not forcibly pry open the cover.
Tape the screwdriver tip before use.
| *1 | Protective Tape |
89071B
2.REMOVE DOOR CONTROL TRANSMITTER MODULE
Using a precision screwdriver, remove the door control transmitter module.
Tape the screwdriver tip before use.
| *1 | Protective Tape |
89758
3.REMOVE DOOR CONTROL TRANSMITTER PACKING
89745A
4.REMOVE TRANSMITTER BATTERY
Twist a coin in the direction of the arrow in the illustration and remove the transmitter battery cover.
Remove the battery (lithium battery: CR2016).
Do not push the terminals with your finger.
Do not forcibly pry up the battery. The terminals may become damaged.
Do not touch the battery with wet hands. Water may cause rust.
Do not touch or move any components inside the transmitter. The transmitter may cease to work.