Home › Vehicle Interior › DOOR LOCK › BACK DOOR LOCK
RM1440E _58 Vehicle Interior _056155 DOOR LOCK _0274061 BACK DOOR LOCK G

DOOR LOCK  BACK DOOR LOCK  INSPECTION  


PROCEDURE

Hide 69350 1.INSPECT BACK DOOR LOCK ASSEMBLY

B453790E01
2.25,2.083 2.5,1.688 true 3.01,2.073 2.927,1.688 true 2.156,1.063 2.344,1.26 0.188,0.198 10 false *a 2.104,2.104 2.458,2.302 0.354,0.198 10 false ACT- 2.833,2.104 3.188,2.302 0.354,0.198 10 false ACT+ 2.083,2.594 2.271,2.781 0.188,0.188 10 false *b 2.01,4.052 2.219,4.229 0.208,0.177 10 false *c

a.

Set the back door lock to the full-latch position.


b.

Apply battery voltage to the door motor connector and check the operation of the door lock motor.

OK:
Measurement Condition Specified Condition
Battery positive (+) → 1 (ACT+)
Battery negative (-) → 4 (ACT-)
Moves to open-latch position


If the result is not as specified, replace the back door lock assembly.



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 (E) - 2 (S) Open-latch Below 1 Ω
3 (E) - 2 (S) Full-latch 10 kΩ or higher


If the result is not as specified, replace the back door lock assembly.


Text in Illustration
*a Component without harness connected
(Back Door Lock Assembly)
*b Full-latch
*c Open-latch