Home › Vehicle Interior › LIGHTING (INT) › ROOM LIGHT(for Front) › 2009.08–2013.08
RM1440E _58 Vehicle Interior _056157 LIGHTING (INT) _0274073 ROOM LIGHT(for Front) G

LIGHTING (INT)  ROOM LIGHT(for Front)  INSPECTION  


PROCEDURE

Hide 81260A 1.INSPECT MAP LIGHT ASSEMBLY

a.
E198779E10
0.844,1.167 1.156,1.188 true 2.24,1.177 2.625,1.177 true 0.74,0.677 0.969,0.677 0.969,0.677 1.302,1.146 true 1.604,0.604 1.479,0.604 1.479,0.604 1.406,1.146 true 2.552,0.677 2.375,0.677 2.375,0.677 1.656,1.156 true 0.208,0.063 0.365,0.24 0.156,0.177 10 false *a 0.469,1.083 0.781,1.26 0.313,0.177 10 false CILL 0.448,0.604 0.719,0.781 0.271,0.177 10 false +B1 1.677,0.542 2.063,0.719 0.385,0.177 10 false ACC1 2.604,0.594 2.896,0.771 0.292,0.177 10 false CTY 2.656,1.094 2.979,1.271 0.323,0.177 10 false GND

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
9 (+B1) - 1 (GND) Spot light switch off 10 kΩ or higher
Spot light switch on Below 1 Ω
9 (+B1) - 6 (CTY) Not door position 10 kΩ or higher
Door position Below 1 Ω


Text in Illustration
*a Component without harness connected
(Map Light Assembly)

If the result is not as specified, replace the map light assembly.


b.

Apply battery voltage to the connector and check the LED illumination.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 8 (ACC1)
Battery negative (-) → Terminal 10 (CILL)
LED illuminates


If the result is not as specified, replace the bulb.