Home › Vehicle Interior › LIGHTING (INT) › ROOM LIGHT(for Front) › from 2013.08
RM1440E _58 Vehicle Interior _056157 LIGHTING (INT) _0274073 ROOM LIGHT(for Front) G

LIGHTING (INT)  ROOM LIGHT(for Front)  INSPECTION  


PROCEDURE

Hide 81260A 1.INSPECT MAP LIGHT ASSEMBLY

a.
E198779E11
0.813,1.177 1.135,1.198 true 2.24,1.177 2.625,1.177 true 1.292,1.167 1.052,0.677 1.052,0.677 0.823,0.677 true 1.604,0.656 1.5,0.656 1.5,0.656 1.417,1.167 true 2.49,0.677 2.208,0.677 2.208,0.677 1.667,1.156 true 0.208,0.094 0.365,0.271 0.156,0.177 10 false *a 0.479,1.104 0.76,1.271 0.281,0.167 10 false ILL- 0.51,0.594 0.781,0.771 0.271,0.177 10 false +B1 1.656,0.583 1.958,0.75 0.302,0.167 10 false ILL+ 2.563,0.604 2.854,0.781 0.292,0.177 10 false CTY 2.688,1.094 3.01,1.271 0.323,0.177 10 false GND

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
9 (+B1) - 1 (GND) Spot light switch off 10 kΩ or higher
Spot light switch on Below 1 Ω
9 (+B1) - 6 (CTY) Not door position 10 kΩ or higher
Door position Below 1 Ω



b.

Apply battery voltage to the connector and check the LED illumination.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 8 (ILL+)
Battery negative (-) → Terminal 10 (ILL-)
LED illuminates


Text in Illustration
*a Component without harness connected
(Map Light Assembly)

If the result is not as specified, replace the map light assembly.