81240
1.REMOVE NO. 1 ROOM LIGHT ASSEMBLY
Using a screwdriver, detach the 4 claws and remove the No. 1 room light lens.
Tape the screwdriver tip before use.
| *1 | Protective Tape |
Using a screwdriver, detach the 2 claws and 2 guides, and remove the 2 No. 1 room light covers.
Tape the screwdriver tip before use.
| *1 | Protective Tape |
Using a screwdriver, detach the 4 claws and disconnect the No. 1 room light assembly as shown in the illustration.
Tape the screwdriver tip before use.
| *1 | Protective Tape |
Using a screwdriver, detach the 4 claws and disconnect the room light switch base from the No. 1 room light assembly.