DATA LIST
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body Electrical / (desired system) / Data List.
According to the display on the intelligent tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| ACC SW | Ignition switch ACC signal / ON or OFF | ON: Ignition switch ACC
OFF: Ignition switch off |
- |
| IG SW | Ignition switch ON signal / ON or OFF | ON: Ignition switch ON
OFF: Ignition switch off |
- |
| RR Door Courtesy SW | Rear door courtesy light switch RH signal / ON or OFF | ON: Rear door RH open
OFF: Rear door RH closed |
- |
| RL Door Courtesy SW | Rear door courtesy light switch LH signal / ON or OFF | ON: Rear door LH open
OFF: Rear door LH closed |
- |
| FR Door Courtesy SW | Front door courtesy light switch RH signal / ON or OFF | ON: Front door RH closed
OFF: Front door RH open |
- |
| FL Door Courtesy SW | Front door courtesy light switch LH signal / ON or OFF | ON: Front door LH closed
OFF: Front door LH open |
- |
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Back Door Courtesy Switch | Back door courtesy light switch signal / ON or OFF | ON: Back door open
OFF: Back door closed |
- |
ACTIVE TEST
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body Electrical / (desired system) / Active Test.
According to the display on the intelligent tester, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Illuminated Entry System | Map light and No. 1 room light | ON/OFF | - |
| Side Mirror Foot Light | Door mirror foot light | ON/OFF | - |
| Cent Consol Spot LGT | Center console spot light | ON/OFF | - |
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Luggage Compartment Light | Spot light | ON/OFF | - |