Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM › from 2013.08
RM1440E _58 Vehicle Interior _056157 LIGHTING (INT) _0274081 LIGHTING SYSTEM U

LIGHTING (INT)  LIGHTING SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


HINT:

Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body Electrical / (desired system) / Data List.


e.

According to the display on the intelligent tester, read the Data List.

Main Body
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
ACC SW Ignition switch ACC signal / ON or OFF ON: Ignition switch ACC
OFF: Ignition switch off
-
IG SW Ignition switch ON signal / ON or OFF ON: Ignition switch ON
OFF: Ignition switch off
-
RR Door Courtesy SW Rear door courtesy light switch RH signal / ON or OFF ON: Rear door RH open
OFF: Rear door RH closed
-
RL Door Courtesy SW Rear door courtesy light switch LH signal / ON or OFF ON: Rear door LH open
OFF: Rear door LH closed
-
FR Door Courtesy SW Front door courtesy light switch RH signal / ON or OFF ON: Front door RH open
OFF: Front door RH closed
-
FL Door Courtesy SW Front door courtesy light switch LH signal / ON or OFF ON: Front door LH open
OFF: Front door LH closed
-

Back Door
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Back Door Courtesy Switch Back door courtesy light switch signal / ON or OFF ON: Back door open
OFF: Back door closed
-



ACTIVE TEST


HINT:

Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body Electrical / (desired system) / Active Test.


e.

According to the display on the intelligent tester, perform the Active Test.

Main Body
Tester Display Test Part Control Range Diagnostic Note
Illuminated Entry System Map light and No. 1 room light ON/OFF -
Side Mirror Foot Light Door mirror foot light ON/OFF -
Relay for Interior Light Auto Cut Function* DOME relay ON/OFF -

*: After turning the ignition switch to ON, proceed to the preceding screen of the active test screen with the intelligent tester and turn the ignition switch off, and perform the active test.


Back Door
Tester Display Test Part Control Range Diagnostic Note
Luggage Compartment Light Spot light ON/OFF -