CUSTOMIZING FUNCTION WITH INTELLIGENT TESTER
The following items can be customized.
When the customer requests a change in a function, first make sure that the function can be customized.
Record the current settings before customizing.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Customize Setting.
Select the setting by referring to the table below.
| Display | Default | Content | Setting |
|---|---|---|---|
| Lighting Time | 15s | Changes the lighting time after closing all of the doors. (It will fade out immediately in case of turning the ignition switch from off to ACC or ON). | 7.5s, 15s or 30s |
| I/L when ACC OFF | ON | A function that turns on the lights when the ignition switch is turned from ON or ACC to off (the room light turns on when the interior light switch is set to DOOR). | ON or OFF |
| I/L ON W/Door Key Unlock | ON | A function that turns on the room light when the door is unlocked with the door key cylinder (the room light turns on when the map light switch is set to DOOR). | ON or OFF |
| Center Console Spot Light | ON | Lights up the center console spot light when ignition switch is turned ACC or ON. | ON or OFF |
| Interior Light Control | ON | Change the ignition key cylinder light control. | ON or OFF |