COMBINATION METER ASSEMBLY
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| 1 (CANH) - Body ground | L - Body ground | CAN communication signal | Ignition switch off | 200 Ω or higher |
| 2 (CANL) - Body ground | W - Body ground | CAN communication signal | Ignition switch off | 200 Ω or higher |
| 4 (TX+) - Body ground | B - Body ground | UART (Accessory meter output) | Ignition switch ON | Pulse generation |
| 5 (RX+) - Body ground | P - Body ground | UART (Accessory meter reset) | Ignition switch ON | Pulse generation |
| 8 (S) - Body ground | V - Body ground | Oil pressure switch signal | Ignition switch ON, oil pressure warning light off | 11 to 14 V |
| Ignition switch ON, oil pressure warning light on | Below 1 V | |||
| 10 (IL2-) - Body ground | GR - Body ground | Illumination signal | Light control switch off | Below 1 V |
| Light control switch in tail or head position | Pulse generation | |||
| 11 (ILL-) - Body ground | GR - Body ground | Illumination signal | Light control switch off | Below 1 V |
| Light control switch in tail or head position | Pulse generation | |||
| 13 (MGND) - Body ground | W-B - Body ground | Ground (Signal ground) | Always | Below 1 V |
| 15 (B) - Body ground | L - Body ground | Battery | Always | 11 to 14 V |
| 17 (+IG) - Body ground | R - Body ground | Ignition switch signal | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V | |||
| 19 (E3) - Body ground | B - Body ground | Ground (Fuel ground) | Always | Below 1 V |
| 20 (E1) - Body ground | W-B - Body ground | Ground | Always | Below 1 V |
| 25 (B) - Body ground | SB - Body ground | Turn indicator light signal | Ignition switch ON, turn RH indicator light off | Below 1 V |
| Ignition switch ON, turn RH indicator light blinking | 11 to 14 V | |||
| 26 (CHG-) - Body ground | P - Body ground | Charge warning light signal | Ignition switch ON, charge warning light off | 11 to 14 V |
| Ignition switch ON, charge warning light on | Below 1 V | |||
| 28 (+S) - Body ground | SB - Body ground | Speed signal for other systems (Output) | Driving at approx. 20 km/h (12 mph) | Pulse generation (See waveform 1) |
| 29 (SI) - Body ground | G - Body ground | Speed signal for other systems (Input) | Driving at approx. 20 km/h (12 mph) | Pulse generation (See waveform 1) |
| 30 (CHK) - Body ground | L - Body ground | MIL (Malfunction Indicator Lamp) signal | Ignition switch ON, MIL (Malfunction Indicator Lamp) off | 11 to 14 V |
| Ignition switch ON, MIL (Malfunction Indicator Lamp) on | Below 1 V | |||
| 33 (B) - Body ground | Y - Body ground | Turn indicator light signal | Ignition switch ON, turn LH indicator light off | Below 1 V |
| Ignition switch ON, turn LH indicator light blinking | 11 to 14 V | |||
| 34 (PBKL) - Body ground | P - Body ground | Passenger seat belt buckle switch signal | Front passenger seat occupied, seat belt fastened | 11 to 14 V |
| Front passenger seat occupied, seat belt unfastened | Below 1 V | |||
| 35 (P/SB) - Body ground | V - Body ground | Passenger seat belt warning light signal | Front passenger seat occupied, seat belt fastened | 11 to 14 V |
| Front passenger seat occupied, seat belt unfastened | Alternating between 11 to 14 V and below 1 V | |||
| 36 (TC) - Body ground*1 | W - Body ground | TAIL cancel switch signal | TAIL cancel switch off | 1 MΩ or higher |
| TAIL cancel switch on | Below 1 Ω | |||
| 37 (RHIG) - Body ground | B - Body ground | Power source for light control rheostat | Ignition switch ON | 4.6 to 5.4 V |
| 38 (TR) - Body ground | GR - Body ground | Light control rheostat signal | Light control rheostat dial fully turned downward | Below 1 Ω |
| Light control rheostat dial fully turned upward | 8 to 12 kΩ | |||
| 39 (E2) - Body ground | LG - Body ground | Light control rheostat switch ground | Always | Below 1 Ω |
| 40 (L) - Body ground | W - Body ground | Fuel level signal | Ignition switch ON, fuel level warning light off | Below 4 V |
| Ignition switch ON, fuel level warning light on | 4 to 9 V |
*1: w/ TAIL Cancel Switch
Using an oscilloscope, check waveform 1.
| Item | Condition |
|---|---|
| Tool setting | 5 V/DIV., 20 ms./DIV. |
| Vehicle condition | Driving at approx. 20 km/h (12 mph) |
When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.
COMBINATION METER ASSEMBLY INNER CIRCUIT
| Terminal No. (Symbol) | Wire Harness Side | |
|---|---|---|
| F14 | 1 (CANH) | CAN communication line |
| 2 (CANL) | CAN communication line | |
| 3 | - | |
| 4 (TX+) | Accessory meter | |
| 5 (RX+) | Accessory meter | |
| 6 | - | |
| 7 | - | |
| 8 (S) | Oil pressure switch | |
| 9 | - | |
| 10 (IL2-) | Each part that uses the illumination signal | |
| 11 (ILL-) | Each part that uses the illumination signal | |
| 12 | - | |
| 13 (MGND) | Ground | |
| 14 | - | |
| 15 (B) | ECU-B fuse | |
| 16 | - | |
| 17 (+IG) | GAUGE fuse | |
| 18 | - | |
| 19 (E3) | Fuel sender gauge assembly | |
| 20 (E1) | Ground | |
| 21 | - | |
| 22 | - | |
| 23 | - | |
| 24 | - | |
| 25 (B) | Turn signal flasher | |
| 26 (CHG-) | Generator | |
| 27 | - | |
| 28 (+S) | Speed signal for other systems (Output) | |
| 29 (SI) | Speed signal for other systems (Input) | |
| 30 (CHK) | ECM | |
| 31 | - | |
| 32 | - | |
| 33 (B) | Turn signal flasher | |
| 34 (PBKL) | Passenger seat belt buckle switch | |
| 35 (P/SB) | Telltale light assembly | |
| 36 (TC) | TAIL cancel switch* | |
| 37 (RHIG) | Light control rheostat | |
| 38 (TR) | Light control rheostat | |
| 39 (E2) | Light control rheostat | |
| 40 (L) | Fuel sender gauge assembly | |
*: w/ TAIL Cancel Switch
ACCESSORY METER ASSEMBLY
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| G3-1 (E) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| G3-2 (DATA) - Body ground | B - Body ground | URAT (Accessory meter communication) signal | Ignition switch ON | Pulse generation |
| G3-3 (TH+) - Body ground | P - Body ground | URAT (Accessory meter communication) signal | Ignition switch ON | Pulse generation |
| G3-5 (IG+) - Body ground | L - Body ground | Engine switch signal | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V | |||
| G3-6 (ACC) - Body ground | P - Body ground | Engine switch signal | Ignition switch off | Below 1 V |
| Ignition switch ACC | 11 to 14 V | |||
| G3-7 (B) - Body ground | L - Body ground | Battery | Always | 11 to 14 V |
| G4-1 (ILL+) - Body ground | G - Body ground | Illumination signal | Light control switch in tail or head position | 11 to 14 V |
| G4-4 (ILL-) - Body ground | GR - Body ground | Illumination signal | Light control switch off | Below 1 V |
| Ignition switch ON, light control switch in tail or head position | Pulse generation |