Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM
RM1440E _58 Vehicle Interior _056158 METER / GAUGE / DISPLAY _0274083 METER / GAUGE SYSTEM C

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  U0100  Lost Communication with ECM / PCM "A"  U0129  Lost Communication with Skid Control ECU  U0131  Lost Communication with Power Steering Control Module  U0151  Lost Communication with Airbag ECU  


DESCRIPTION

The combination meter assembly communicates with the ECM via the CAN communication system (CAN No. 1 Bus).

DTC Code DTC Detection Condition Trouble Area
U0100 IG voltage is 9.5 V or higher and the following condition is met:
1.

No communication with the ECM continues for 2 seconds or more.


·

ECM

·

CAN communication system

·

Combination meter assembly


U0129 IG voltage is 9.5 V or higher and the following condition is met:
1.

No communication with the skid control ECU continues for 3 seconds or more.


·

Master cylinder solenoid (Skid control ECU)

·

CAN communication system

·

Combination meter assembly


U0131 IG voltage is 9.5 V or higher and the following condition is met:
1.

No communication with the power steering ECU continues for 3 seconds or more.


·

Power steering ECU assembly

·

CAN communication system

·

Combination meter assembly


U0151 IG voltage is 9.5 V or higher and the following condition is met:
1.

No communication with the center airbag sensor assembly continues for 10 seconds or more.


·

Center airbag sensor assembly

·

CAN communication system

·

Combination meter assembly



PROCEDURE

1.CONFIRM DTC OUTPUT
a.

Check for DTCs (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is output A
DTC is not output B

HINT:

If CAN communication system DTC U0100, U0129, U0131 or U0151 and another DTC are output at the same time, perform troubleshooting for CAN communication system DTC U0100, U0129, U0131 or U0151 first.




A

B