Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM
RM1440E _58 Vehicle Interior _056160 SUPPLEMENTAL RESTRAINT SYSTEMS _0274089 AIRBAG SYSTEM C

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  B1000/31  Center Airbag Sensor Assembly Malfunction  


DESCRIPTION

The center airbag sensor consists of the airbag sensor, safing sensor, drive circuit, diagnosis circuit, ignition control, etc.

If the center airbag sensor receives signals from the airbag sensor, it determines whether the SRS should be activated.

DTC B1000/31 is stored when a malfunction is detected in the center airbag sensor.

DTC Code DTC Detection Condition Trouble Area
B1000/31 A center airbag sensor malfunction. Center airbag sensor assembly

HINT:

When a trouble code is output simultaneously with B1000/31, repair the malfunction indicated by the other code first.


CAUTION / NOTICE / HINT

NOTICE:

When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


PROCEDURE

1.CHECK CENTER AIRBAG SENSOR
a.

Turn the ignition switch off.


b.

Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.


c.

Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.


d.

Turn the ignition switch to ON, and wait for at least 60 seconds.



f.

Turn the ignition switch off.


g.

Turn the ignition switch to ON, and wait for at least 60 seconds.


h.

Check for DTCs (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).

OK:

DTC B1000 is not output.




OK

NG