Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM
RM1440E _58 Vehicle Interior _056160 SUPPLEMENTAL RESTRAINT SYSTEMS _0274089 AIRBAG SYSTEM C

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  B1610/13  Front Airbag Sensor RH Malfunction  


DESCRIPTION

The front airbag sensor RH consists of the diagnostic circuit and frontal deceleration sensor, etc.

If the center airbag sensor receives signals from the frontal deceleration sensor, it determines whether the SRS should be activated.

DTC B1610/13 is stored when a malfunction is detected in the front airbag sensor RH circuit.

DTC Code DTC Detection Condition Trouble Area
B1610/13 Either condition is met:
·

A front airbag sensor RH malfunction.

·

A center airbag sensor malfunction.


·

Front airbag sensor RH

·

Center airbag sensor assembly



WIRING DIAGRAM

C213916E35
5.583,3.823 5.885,3.99 0.302,0.167 10 false F33 0.438,3.854 0.74,4.021 0.302,0.167 10 false A35 3.594,2.208 3.938,2.448 0.344,0.24 10 false FA4 1.719,0.885 2.021,1.052 0.302,0.167 10 false 2 1.719,2.073 2.021,2.24 0.302,0.167 10 false 1 5.313,0.885 5.615,1.052 0.302,0.167 10 false 29 5.313,2.073 5.615,2.24 0.302,0.167 10 false 27 3.625,0.802 3.927,0.969 0.302,0.167 10 false 1 3.646,1.979 3.948,2.146 0.302,0.167 10 false 2 3.594,1.031 3.885,1.198 0.292,0.167 10 false FA4 5.625,1.031 6.042,1.313 0.417,0.281 10 false +SR 5.615,2.198 6.125,2.479 0.51,0.281 10 false -SR 1.292,1.042 1.75,1.344 0.458,0.302 10 false +SR 1.292,2.208 1.76,2.563 0.469,0.354 10 false -SR 0.438,4.01 2,4.188 1.563,0.177 10 false Front Airbag Sensor RH 5.583,4 6.969,4.198 1.385,0.198 10 false Center Airbag Sensor

CAUTION / NOTICE / HINT

NOTICE:

When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


PROCEDURE

1.CHECK FRONT AIRBAG SENSOR RH
C148689E20
0.617,1.104 0.787,1.264 0.170,0.161 10 *1 2.02,1.104 2.190,1.278 0.170,0.174 10 *2

a.

Turn the ignition switch off.


b.

Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.


c.

Interchange the front airbag sensor LH with RH and connect the connectors to them.


d.

Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.


e.

Turn the ignition switch to ON, and wait for at least 60 seconds.



g.

Turn the ignition switch off.


h.

Turn the ignition switch to ON, and wait for at least 60 seconds.


i.

Check for DTCs (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC B1610 is output A
DTC B1615 is output B
DTC B1610 and B1615 are not output C

HINT:

Codes other than DTC B1610 and B1615 may be output at this time, but they are not related to this check.


Text in Illustration
*1 Front Airbag Sensor LH
*2 Center Airbag Sensor



C

A

B