Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM
RM1440E _58 Vehicle Interior _056160 SUPPLEMENTAL RESTRAINT SYSTEMS _0274089 AIRBAG SYSTEM C

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  B1675/82  Rear Floor Airbag Sensor Malfunction  


DESCRIPTION

The rear floor side airbag sensor consists of the diagnostic circuit, rear floor deceleration sensor, etc.

If the center airbag sensor receives signals from the rear floor deceleration sensor, it determines whether the SRS should be activated.

DTC B1675/82 is stored when a malfunction is detected in the rear floor side airbag sensor circuit.

DTC Code DTC Detection Condition Trouble Area
B1675/82 Either condition is met:
·

A rear floor side airbag sensor malfunction.

·

A center airbag sensor malfunction.


·

Rear floor side airbag sensor

·

Center airbag sensor assembly



WIRING DIAGRAM

C216829E12
1.188,1.354 1.604,1.51 0.417,0.156 10 false BER+ 1.208,2.698 1.625,2.854 0.417,0.156 10 false BER- 5.677,1.354 6.094,1.51 0.417,0.156 10 false BDR+ 5.677,2.688 6.094,2.844 0.417,0.156 10 false BDR- 1.677,1.25 1.833,1.396 0.156,0.146 10 false 2 1.688,2.583 1.844,2.75 0.156,0.167 10 false 1 5.396,1.292 5.615,1.448 0.219,0.156 10 false 21 5.385,2.615 5.625,2.771 0.24,0.156 10 false 22 0.271,3.792 0.594,3.979 0.323,0.188 10 false N6 0.271,3.969 2.229,4.208 1.958,0.24 10 false Rear Floor Side Airbag Sensor 5.448,3.802 5.885,3.99 0.438,0.188 10 false N1 5.448,3.979 6.875,4.146 1.427,0.167 10 false Center Airbag Sensor

CAUTION / NOTICE / HINT

NOTICE:

When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


PROCEDURE

1.CHECK REAR FLOOR SIDE AIRBAG SENSOR
a.
C171812E03
0.666,1.37 0.817,1.539 0.151,0.170 10 *1 1.801,1.37 1.993,1.539 0.192,0.170 10 *2

Turn the ignition switch off.


b.

Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.


c.

Temporarily replace the rear floor side airbag sensor with a new one.


d.

Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.


e.

Turn the ignition switch to ON, and wait for at least 60 seconds.



g.

Turn the ignition switch off.


h.

Turn the ignition switch to ON, and wait for at least 60 seconds.


i.

Check for DTCs (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).

OK:

DTC B1675 is not output.


HINT:

Codes other than DTC B1675 may be output at this time, but they are not related to this check.


Text in Illustration
*1 Rear Floor Side Airbag Sensor
*2 Center Airbag Sensor



OK

NG