Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › STEERING PAD
RM1440E _58 Vehicle Interior _056160 SUPPLEMENTAL RESTRAINT SYSTEMS _0274090 STEERING PAD A

SUPPLEMENTAL RESTRAINT SYSTEMS  STEERING PAD  INSTALLATION  


PROCEDURE

Hide 45130 1.INSTALL STEERING PAD

a.
B238311

Support the steering pad with one hand.


b.

Connect the 2 connectors to the steering pad.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



c.

Connect the horn connector.


d.

Confirm that the groove along the cireumfevence of the "TORX" screw is attached to the screw case, and place the steering pad onto the steering wheel.


e.

Using a T30 "TORX" socket wrench, tighten the 2 screws.

Torque:
8.8 N*m (90 kgf*cm, 78 in.*lbf)


Hide 45187 2.INSTALL LOWER NO. 3 STEERING WHEEL COVER

a.

Attach the 2 claws to install the cover.


Hide 45186 3.INSTALL LOWER NO. 2 STEERING WHEEL COVER

a.
B238308E01
0.11,0.036 0.303,0.251 0.193,0.214 10 *A 0.108,2.079 0.301,2.293 0.193,0.214 10 *B

Attach the 2 claws to install the cover.

Text in Illustration
*A w/o Cruise Control System
*B w/ Cruise Control System


Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 45130 5.INSPECT STEERING PAD

a.

With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:

Cuts, minute cracks or marked discoloration on the steering pad top surface or in the grooved portion.


b.

Make sure that the horn sounds.

If the horn does not sound, inspect the horn system.


Hide 6.CHECK SRS WARNING LIGHT