Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › STEERING PAD
RM1440E _58 Vehicle Interior _056160 SUPPLEMENTAL RESTRAINT SYSTEMS _0274090 STEERING PAD A

SUPPLEMENTAL RESTRAINT SYSTEMS  STEERING PAD  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 45187 2.REMOVE LOWER NO. 3 STEERING WHEEL COVER

a.
B238307

Detach the 2 claws and remove the cover.


Hide 45186 3.REMOVE LOWER NO. 2 STEERING WHEEL COVER

a.
B238308E01
0.11,0.036 0.303,0.251 0.193,0.214 10 *A 0.108,2.079 0.301,2.293 0.193,0.214 10 *B

Detach the 2 claws and remove the cover.

Text in Illustration
*A w/o Cruise Control System
*B w/ Cruise Control System


Hide 45130 4.REMOVE STEERING PAD

a.
B246940E01
1.807,2.208 1.963,2.389 0.156,0.181 10 *1 1.956,2.294 2.052,2.294 false 2.052,2.294 2.321,2.479 false

Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case.

Text in Illustration
*1 Screw Case


b.
B238310

Pull out the steering pad from the steering wheel as shown in the illustration. Then support the steering pad with one hand.

NOTICE:

When removing the steering pad, do not pull the airbag wire harness.



c.

Disconnect the horn connector.


d.

Disconnect the 2 connectors and remove the steering pad.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.