Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY(for Power Seat) › 2009.08–2013.08
RM1440E _58 Vehicle Interior _056161 SEAT _0274104 FRONT SEAT ASSEMBLY(for Power Seat) A

SEAT  FRONT SEAT ASSEMBLY(for Power Seat)  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.


HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.INSTALL FRONT SEAT ASSEMBLY

a.

Place the front seat assembly in the cabin.

NOTICE:

Be careful not to damage the vehicle body.



b.

Connect the seat wire connectors under the seat.


c.

Temporarily install the front seat assembly with the 4 bolts.


d.

Connect the cable to the negative (-) battery terminal.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



e.

Operate the power seat switch to move the seat to the rearmost position.


f.
B239529E03
1.083,0.208 1.292,0.406 0.208,0.198 10 false (1) 1.979,1.333 2.188,1.531 0.208,0.198 10 false (2)

Tighten the bolts in the order indicated in the illustration.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


g.

Operate the power seat switch to move the seat to the foremost position.


h.
B238103E03
2.677,0.802 2.875,1.01 0.198,0.208 10 false (1) 0.938,1.24 1.135,1.448 0.198,0.208 10 false (2)

Tighten the bolts in the order indicated in the illustration.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


Hide 72138 2.INSTALL OUTER SEAT TRACK COVER LH

B238102

a.

Move the cover in the direction of the arrow to attach the 4 guides.


b.

Attach the 2 claws to install the cover.


Hide 72158 3.INSTALL INNER SEAT TRACK BRACKET COVER LH

B238100

a.

Move the cover in the direction of the arrow to attach the 2 guides.


b.

Attach the 2 claws to install the cover.


Hide 72124 4.INSTALL FRONT SEAT OUTER TRACK BRACKET COVER LH

a.

Operate the power seat switch to move the seat to the rearmost position.


b.
B239527

Move the cover in the direction of the arrow to attach the 2 claws and guide.


c.

Attach the 2 claws to install the cover.


Hide 72128A 5.INSTALL FRONT SEAT INNER TRACK BRACKET COVER LH

B241795

a.

Move the cover in the direction of the arrow to attach the 2 guides.


b.

Attach the 2 claws to install the cover.


Hide 71910A 6.INSTALL FRONT SEAT HEADREST ASSEMBLY

a.

Install the front seat headrest.


Hide 7.CHECK SRS WARNING LIGHT

Hide 8.INSPECT FRONT SEAT ASSEMBLY


b.

w/ Seat Heater System:

Check the seat heater operation.

i.

Turn the ignition switch to ON.


ii.

Turn the seat heater switch on.


iii.

Wait 5 minutes or more and confirm that the seat surface becomes warm.