84920
1.INSPECT LUMBAR SWITCH ASSEMBLY
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 3 (H) - 5 (B) | Hold | Below 1 Ω |
| 1 (R) - 2 (E2) | ||
| 2 (E2) - 3 (H) | Off | |
| 2 (E2) - 1 (R) | ||
| 2 (E2) - 3 (H) | Release | |
| 1 (R) - 5 (B) |
If the result is not as specified, replace the lumbar switch.
| *1 | Hold Switch |
| *2 | Release Switch |
| *a | Component without harness connected
(Lumbar Switch) |