Home › Vehicle Interior › SEAT › FRONT SEAT CUSHION HEATER › 2009.08–2013.08
RM1440E _58 Vehicle Interior _056161 SEAT _0274114 FRONT SEAT CUSHION HEATER G

SEAT  FRONT SEAT CUSHION HEATER  INSPECTION  


PROCEDURE

Hide 71072S 1.INSPECT SEPARATE TYPE FRONT SEAT CUSHION COVER LH

B239582E01
1.155,2.795 1.354,2.968 0.199,0.172 10 *1 2.401,2.795 2.600,2.968 0.199,0.172 10 *2 0.433,2.238 0.632,2.410 0.199,0.172 10 *a

a.

Check the seat cushion heater.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A-1 - B-1 Seat cushion heater temperature 20°C (68°F) 3.4 to 4.2 Ω
A-4 - B-2
A-1 - A-4
A-2 - A-3 8 to 12 kΩ


If the result is not as specified, replace the separate type front seat cushion cover.

Text in Illustration
*1 Connector A
*2 Connector B
*a Component without harness connected
(Separate Type Front Seat Cushion Cover (Front Seat Cushion Heater))



Hide 71071S 2.INSPECT SEPARATE TYPE FRONT SEAT CUSHION COVER RH

B239583E01
1.092,2.597 1.291,2.769 0.199,0.172 10 *1 2.424,2.597 2.623,2.769 0.199,0.172 10 *2 0.457,2.228 0.655,2.401 0.199,0.172 10 *a

a.

Check the seat cushion heater.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A-1 - B-1 Seat cushion heater temperature 20°C (68°F) 3.4 to 4.2 Ω
A-4 - B-2
A-1 - A-4
A-2 - A-3 8 to 12 kΩ


If the result is not as specified, replace the separate type front seat cushion cover.

Text in Illustration
*1 Connector A
*2 Connector B
*a Component without harness connected
(Separate Type Front Seat Cushion Cover (Front Seat Cushion Heater))