87501B
1.INSPECT SEAT HEATER CONTROL SUB-ASSEMBLY LH
Disconnect the b20 seat heater control sub-assembly LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| b20-6 (E) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| b20-1 (SWL) - b20-6 (E) | Ignition switch to ON
Refreshing seat switch LH side off |
Below 1 V |
| Ignition switch to ON
Refreshing seat switch LH side on |
11 to 14 V | |
| b20-4 (B) - b20-6 (E) | Ignition switch to OFF | Below 1 V |
| Ignition switch to ON | 11 to 14 V |
| *a | Front view of wire harness connector
(to Seat Heater Control Sub-assembly LH) |
If the result is not as specified, there may be a malfunction on the wire harness side.
Connect the b20 seat heater control sub-assembly LH connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| b20-5 (THL) - Body ground | Ignition switch to ON
Refreshing seat switch LH on, MIN → MAX |
Gradual increase between value below 1 V and value from 11 to 14 V |
| *a | Component with harness connected
(Seat Heater Control Sub-assembly LH) |
If the result is not as specified, the seat heater control sub-assembly LH may have a malfunction.
87501A
2.INSPECT SEAT HEATER CONTROL SUB-ASSEMBLY RH
Disconnect the a15 seat heater control sub-assembly LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| a15-6 (E) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| a15-1 (SWR) - a15-6 (E) | Ignition switch to ON
Refreshing seat switch RH side off |
Below 1 V |
| Ignition switch to ON
Refreshing seat switch RH side on |
11 to 14 V | |
| a15-4 (B1) - a15-6 (E) | Ignition switch to OFF | Below 1 V |
| Ignition switch to ON | 11 to 14 V |
| *a | Front view of wire harness connector
(to Seat Heater Control Sub-assembly RH) |
If the result is not as specified, there may be a malfunction on the wire harness side.
Connect the a15 seat heater control sub-assembly LH connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| a15-5 (THR) - Body ground | Ignition switch to ON
Refreshing seat switch RH side on, MIN → MAX |
Gradual increase between value below 1 V and value from 11 to 14 V |
| *a | Component with harness connected
(Seat Heater Control Sub-assembly RH) |
If the result is not as specified, the seat heater control sub-assembly LH may have a malfunction.