CHECK COMBINATION METER ASSEMBLY
Disconnect the F14 combination meter assembly connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| F14-13 (MGND) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| F14-15 (B) - Body ground | L- Body ground | Combination meter B line | Always | 11 to 14 V |
| F14-17 (+IG) - Body ground | R - Body ground | Combination meter +IG line | Ignition switch ON | 11 to 14 V |
| F14-20 (E1) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
If the result is not as specified, there may be a malfunction on the wire harness side.
Reconnect the F14 combination meter assembly connector.
Measure the voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| F14-34 (PBKL) - Body ground | P - Body ground | Front passenger seat belt signal | Front passenger seat occupied, seat belt fastened | 11 to 14 V |
| Front passenger seat occupied, seat belt unfastened | Below 1 V |
If the result is not as specified, the combination meter assembly may have a malfunction.
CHECK CENTER AIRBAG SENSOR ASSEMBLY
| Terminal No. | Symbol | Description |
|---|---|---|
| O1-10 | LBE+ | Front seat inner belt assembly LH (Seat belt buckle switch LH) |
| O1-18 | LBE- | Front seat inner belt assembly LH (Seat belt buckle switch LH) |