Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM
RM1440E _58 Vehicle Interior _056162 SEAT BELT _0274120 SEAT BELT WARNING SYSTEM U

SEAT BELT  SEAT BELT WARNING SYSTEM  DATA LIST / ACTIVE TEST  


READ DATA LIST


HINT:

Using the intelligent tester to read the Data List allows values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / (desired system) / Data List.


e.

According to the display on the intelligent tester, read the Data List.

Combination Meter
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
P-Seatbelt Buckle SW Front passenger side seat belt buckle signal / ON or OFF ON: Front passenger side seat belt fastened
OFF: Front passenger side seat belt unfastened
-
Driver Side Seatbelt Warning Buzzer Driver side seat belt warning buzzer signal / ON or OFF ON: Seat belt warning buzzer enabled
OFF: Seat belt warning buzzer disabled
The current customize setting is displayed.
P-Seatbelt Warning Buzzer Front passenger side seat belt warning buzzer signal / ON or OFF ON: Seat belt warning buzzer enabled
OFF: Seat belt warning buzzer disabled
The current customize setting is displayed.

SRS Airbag
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Left side Buckle SW Front LH side seat belt buckle switch / Unset, Set or NG Unset: Seat belt unfastened
Set: Seat belt fastened
NG: Condition undetermined
-



PERFORM ACTIVE TEST


HINT:

Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / Combination Meter / Active Test.


e.

According to display on the intelligent tester, perform the Active Test.

Combination Meter
Tester Display Test Part Control Range Diagnostic Note
Driver Side Seat Belt Driver side seat belt warning light ON/OFF Confirm that the vehicle is stopped and the engine is idling.
Front Passenger Side Seat Belt Front passenger side seat belt warning light ON/OFF Confirm that the vehicle is stopped and the engine is idling.