88410
1.INSPECT MAGNET CLUTCH ASSEMBLY
Check the magnet clutch operation.
Confirm that the magnet clutch hub and magnet clutch rotor lock when the battery positive lead is connected to terminal 3 of the magnet clutch, and the negative lead is connected to the ground wire.
If the operation is not as specified, replace the magnet clutch assembly.
| *1 | Magnet Clutch Rotor |
| *2 | Magnet Clutch Hub |
| *3 | Battery |
| *a | Component without harness connected
(Magnet Clutch Assembly) |
Measure the resistance.
Measure the resistance between terminals 1 and 2.
65 to 125 Ω at 20°C (68°F)
If the resistance is not as specified, replace the cooler compressor assembly.