Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)
RM1440E _58 Vehicle Interior _056163 HEATING / AIR CONDITIONING _0274152 AIR CONDITIONING SYSTEM(for Manual Air Conditioning System) J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)  Back-up Power Source Circuit  


DESCRIPTION

The back-up power source circuit for the air conditioning amplifier assembly is shown below. Power is supplied even after the ignition switch is turned off and is used for diagnostic trouble code memory, etc.

WIRING DIAGRAM

E179959E16
0.19,0.895 1.022,1.134 0.832,0.239 10 from Battery 3.09,1.08 3.415,1.273 0.325,0.193 10 A/C 5.187,0.805 5.389,1.016 0.202,0.211 10 21 5.467,0.903 5.744,1.068 0.276,0.165 10 B 4.832,1.968 5.127,2.152 0.295,0.184 10 F42 4.823,2.117 7.127,2.310 2.304,0.193 10 Air Conditioning Amplifier Assembly

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BATTERY)
a.
U181040E02
2.75,2.51 2.958,2.865 true 0.135,0.073 0.323,0.24 0.188,0.167 10 false *a 0.26,2.021 0.573,2.188 0.313,0.167 10 false F42 2.969,2.906 3.146,3.052 0.177,0.146 10 false B

Disconnect the F42 amplifier connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
F42-21 (B) - Body ground Always 11 to 14 V


Text in Illustration
*a Rear view of wire harness connector
(to Air Conditioning Amplifier Assembly)



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR