55474C
1.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
Open the instrument cluster finish panel lid.
Put protective tape around the No. 1 instrument cluster finish panel garnish.
Grip the No. 1 instrument cluster finish panel garnish and pull it diagonally upward toward the rear to detach the 5 clips and remove the No. 1 instrument cluster finish panel garnish.
| *1 | Protective Tape | - | - |
55475A
2.REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
Use the same procedure described for the No. 1 instrument cluster finish panel garnish.
58816B
3.REMOVE FRONT NO. 1 CONSOLE BOX INSERT
Detach the 2 clips and guide and remove the front No. 1 console box insert.
58817A
4.REMOVE FRONT NO. 2 CONSOLE BOX INSERT
Detach the 2 clips and guide and remove the front No. 2 console box insert.
33504F
5.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
Twist the shift lever knob in the direction indicated by the arrow and remove it.
58804A
6.REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
Put protective tape around the upper console panel.
| *1 | Protective Tape |
Using a moulding remover, detach the 10 clips.
Disconnect each connector and remove the upper console panel.
| *A | for 2WD | *B | for 4WD |
| *1 | Protective Tape | - | - |
58987A
7.REMOVE NO. 2 CONSOLE BOX RETAINER
Detach the clips, 2 claws and 2 guides and remove the No. 2 console box retainer.
58910C
8.REMOVE REAR CONSOLE BOX ASSEMBLY
Remove the 4 bolts.
Detach the 2 guides.
Disconnect each connector and remove the rear console box.