Home › Vehicle Exterior › WINDOW / GLASS › WINDOW DEFOGGER SYSTEM
RM1440E _59 Vehicle Exterior _056166 WINDOW / GLASS _0274160 WINDOW DEFOGGER SYSTEM U

WINDOW / GLASS  WINDOW DEFOGGER SYSTEM  TERMINALS OF ECU  


CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY


U150422E02
3.99,0.198 4.271,0.344 0.281,0.146 10 false F42

a.

Disconnect the F42 air conditioning amplifier connector.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
F42-21 (B) - F42-14 (GND) V - W-B Battery power source Always 11 to 14 V
F42-1 (IG+) - F42-14 (GND) L - W-B Ignition switch power supply Ignition switch ON 11 to 14 V
F42-1 (IG+) - F42-14 (GND) L - W-B Ignition switch power supply Ignition switch off Below 1 V
F42-14 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω

If the result is not as specified, there may be a malfunction on the wire harness side.



c.

Reconnect the F42 air conditioning amplifier connector.


d.

Measure the voltage according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
F42-38 (RDEF) - F42-14 (GND) P - W-B Rear defogger signal Ignition switch ON, rear window defogger switch off 11 to 14 V
F42-38 (RDEF) - F42-14 (GND) P - W-B Rear defogger signal Ignition switch ON, rear window defogger switch on Below 1 V

If the result is not as specified, there may be a malfunction in the air conditioning amplifier.




CHECK HEATER CONTROL ASSEMBLY


U149675E02
3.427,0.177 3.708,0.344 0.281,0.167 10 false F29

a.

Disconnect the F29 heater control connector.


b.

Measure the resistance and voltage according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
F29-4 (IG+) - F29-11 (GND) L - W-B Ignition switch power supply Ignition switch ON 11 to 14 V
F29-4 (IG+) - F29-11 (GND) L - W-B Ignition switch power supply Ignition switch off Below 1 V
F29-11 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω

If the result is not as specified, there may be a malfunction on the wire harness side.