Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM
RM1440E _59 Vehicle Exterior _056166 WINDOW / GLASS _0274161 POWER WINDOW CONTROL SYSTEM J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  All Power Windows do not Operate with Driver Side Door Key Cylinder or Wireless Transmitter  


DESCRIPTION

·

When a key switch is pushed: 1) the door control receiver receives the key signal; 2) the door control receiver sends a signal to the certification ECU; 3) the main body ECU (multiplex network body ECU) sends the operation permission signal to the power window regulator motors; and 4) the power window regulator motor assemblies are activated.

·

When the driver door key cylinder (key-linked switch) is turned: 1) the door lock motor receives the signal; 2) the main body ECU (multiplex network body ECU) sends the signal to the power window regulator motors; and 3) the power window regulator motor assemblies are activated.


CAUTION / NOTICE / HINT

HINT:

Since the power window control system has functions that use LIN communication, first confirm that there is no malfunction in the communication system by inspecting the LIN communication functions in accordance with the "How to Proceed with Troubleshooting" procedures. Then, conduct the following inspection procedure.


PROCEDURE

1.CHECK BASIC FUNCTION (WIRELESS AND POWER DOOR LOCK CONTROL SYSTEM)
a.

Check that the wireless transmitter (See page Vehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK CONTROL SYSTEM>OPERATION CHECK) and driver door key cylinder (key-linked switch) (See page Vehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>OPERATION CHECK) lock and unlock all the doors normally.

Result
Result Proceed to
Transmitter and driver door key cylinder operate normally A
Transmitter does not operate normally B
Driver door key cylinder does not operate normally D



A

2.CHECK MANUAL UP/DOWN FUNCTION

B

C

2.CHECK MANUAL UP/DOWN FUNCTION
a.

Check that the manual up/down function using the multiplex network master switch and power window regulator switches can operate all the power windows (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK).

OK:

Manual up/down function is normal.




OK

3.CHECK REMOTE UP/DOWN FUNCTION

NG

GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table)

3.CHECK REMOTE UP/DOWN FUNCTION
a.

Check that the remote up/down function using the multiplex network master switch operates the power windows (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK).

OK:

Remote up/down function is normal.




OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG

GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table)