Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM
RM1440E _59 Vehicle Exterior _056166 WINDOW / GLASS _0274161 POWER WINDOW CONTROL SYSTEM C

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  B2312  Back Door Power Window Switch ON Stuck  


DESCRIPTION

This DTC is stored when the back door power window regulator motor is stuck.

NOTICE:

When a power window regulator is reinstalled or replaced, the power window control system must be initialized.


Back Door P/W
DTC Code DTC Detection Condition Trouble Area
B2312 The back door power window regulator motor is stuck.
·

Multiplex network door ECU (Back door P/W)

·

Back door power window regulator motor

·

Harness or connector



WIRING DIAGRAM

B245647E03
0.604,2.802 2.26,3.396 1.656,0.594 10 false Back Door Power Window Regulator Motor Assembly 4.771,2.781 6.76,3.323 1.99,0.542 10 false Multiplex Network Door ECU (Back Door P/W) 5.146,0.479 5.688,0.76 0.542,0.281 10 false AUT2 4.792,0.396 5.115,0.594 0.323,0.198 10 false 12 5.135,1.031 5.719,1.313 0.583,0.281 10 false BUP2 5.135,1.563 5.823,1.927 0.688,0.365 10 false BDN2 1.333,1.563 1.885,1.813 0.552,0.25 10 false DOWN 1.583,1.031 2.167,1.281 0.583,0.25 10 false UP 1.406,0.49 2.104,0.792 0.698,0.302 10 false AUTO 4.792,0.896 5.229,1.167 0.438,0.271 10 false 14 4.802,1.448 5.167,1.656 0.365,0.208 10 false 13 5.135,2.104 5.802,2.469 0.667,0.365 10 false E4 4.854,1.979 5.063,2.25 0.208,0.271 10 false 1 1.969,0.396 2.156,0.573 0.188,0.177 10 false 4 1.948,0.917 2.271,1.146 0.323,0.229 10 false 10 1.958,1.448 2.198,1.656 0.24,0.208 10 false 7 1.469,2.094 1.99,2.354 0.521,0.26 10 false GND 1.969,2 2.344,2.375 0.375,0.375 10 false 1 0.615,2.604 0.927,2.802 0.313,0.198 10 false W9 4.771,2.583 5.229,2.781 0.458,0.198 10 false W10

PROCEDURE

1.CHECK FOR DTC

b.

Check for DTCs (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
No DTCs output A
DTC B2312 is output B



A

END

B

2.CHECK MULTIPLEX NETWORK DOOR ECU (BACK DOOR P/W)
2.CHECK MULTIPLEX NETWORK DOOR ECU (BACK DOOR P/W)
a.

Measure the resistance according to the value(s) in the table below.

U149819E01
3.192,1.998 3.574,2.147 0.382,0.149 10 AUT2 2.477,1.998 2.873,2.147 0.396,0.149 10 BDN2 1.37,2.278 1.766,2.427 0.396,0.149 10 BUP2 4.152,1.665 4.499,1.814 0.347,0.149 10 GND 4.38,2.753 4.681,2.063 4.681,2.063 4.811,2.063 false 4.833,1.999 5.031,2.148 0.198,0.149 10 E4 4.667,0.097 5.482,0.281 0.816,0.184 10 Waveform 2 1.052,0.097 1.867,0.281 0.816,0.184 10 Waveform 1 3.961,2.857 3.705,2.062 3.705,2.062 3.572,2.062 false 3.846,2.093 4.168,2.254 0.323,0.161 10 W10 0.557,1.674 0.886,1.837 0.330,0.163 10 GND 3.887,2.858 3.001,2.06 3.001,2.06 2.874,2.06 false 3.797,2.863 1.889,2.347 1.889,2.347 1.758,2.347 false

Standard Voltage:
Tester Connection Tool Setting Switch Condition Specified Condition
W10-14 (BUP2) - W10-1 (E4) 2 V/DIV., 100 ms/DIV. Ignition switch ON, back door power window regulator switch up Pulse generation (See waveform 1)
W10-13 (BDN2) - W10-1 (E4) 2 V/DIV., 100 ms/DIV. Ignition switch ON, back door power window regulator switch down Pulse generation (See waveform 1)
W10-12 (AUT2) - W10-1 (E4) 2 V/DIV., 100 ms/DIV. Ignition switch ON, back door power window auto up or auto down function operating Pulse generation (See waveform 2)




OK

3.CHECK HARNESS AND CONNECTOR (MULTIPLEX NETWORK DOOR ECU - BACK DOOR POWER WINDOW REGULATOR MOTOR ASSEMBLY)

NG

REPLACE MULTIPLEX NETWORK DOOR ECU (BACK DOOR P/W)

3.CHECK HARNESS AND CONNECTOR (MULTIPLEX NETWORK DOOR ECU - BACK DOOR POWER WINDOW REGULATOR MOTOR ASSEMBLY)
a.

Disconnect the W9 back door power window regulator motor connector.


b.

Disconnect the W10 multiplex network door ECU connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
W9-10 (UP) - V10-14 (BUP2) Always Below 1 Ω
W9-7 (DOWN) - V10-13 (BDN2) Always Below 1 Ω
W9-4 (AUTO) - V10-12 (AUT2) Always Below 1 Ω
W9-1 (GND) - V10-1 (E4) Always Below 1 Ω
W9-10 (UP) - Body ground Always 10 kΩ or higher
W9-7 (DOWN) - Body ground Always 10 kΩ or higher
W9-4 (AUTO) - Body ground Always 10 kΩ or higher
W9-1 (GND) - Body ground Always 10 kΩ or higher




OK

REPLACE BACK DOOR POWER WINDOW REGULATOR MOTOR ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR