Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM
RM1440E _59 Vehicle Exterior _056166 WINDOW / GLASS _0274161 POWER WINDOW CONTROL SYSTEM C

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  B2313  Back Door Power Window Position/Seal Characteristics Data is not Memorized  


DESCRIPTION

The power window regulator motor is driven by operating the back door power window regulator switch. The power window regulator motor assembly has a motor and ECU.

When the ECU determines that the power window regulator motor has not been initialized, DTC B2313 is stored.

HINT:

This DTC may be stored for all the windows.


NOTICE:
·

When a power window regulator motor is reinstalled or replaced, the power window control system must be initialized.

·

After any door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the auto up function is used. In such cases, the auto up function can be resumed by repeating the following operation at least 5 times:

1.

Close the power window by fully pulling up the power window switch and holding it in the auto up position.

2.

Open the power window by fully pushing down the power window switch.




Back Door P/W
DTC Code DTC Detection Condition Trouble Area
B2313 Either condition is met:
·

Power window regulator motor is not initialized.

·

Power window regulator motor malfunctions.


Back door power window regulator motor

PROCEDURE

1.PERFORM INITIALIZATION (APPLICABLE LOCATION)
a.

Initialize the power window regulator motor (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).



NEXT

2.CHECK DTC
2.CHECK DTC

b.

Check for DTCs (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
No DTCs output A
DTC B2313 is output B



A

END (POWER WINDOW CONTROL SYSTEM WAS NOT INITIALIZED)

B

REPLACE BACK DOOR POWER WINDOW REGULATOR MOTOR ASSEMBLY