Home › Vehicle Exterior › WINDOW / GLASS › REAR POWER WINDOW SWITCH
RM1440E _59 Vehicle Exterior _056166 WINDOW / GLASS _0274164 REAR POWER WINDOW SWITCH G

WINDOW / GLASS  REAR POWER WINDOW SWITCH  INSPECTION  


PROCEDURE

Hide 84810D 1.INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY

a.
U147959E02
2,2.625 2.417,2.333 2.417,2.333 2.531,2.333 false 1.854,2.948 2.396,3.24 2.396,3.24 2.479,3.24 false 1.365,2.677 1,2.333 1,2.333 0.875,2.333 false 1.333,2.938 1,2.688 1,2.688 0.896,2.688 false 1.552,2.969 1.021,3.167 1.021,3.167 0.906,3.167 false 1.656,0.563 2.083,0.198 2.083,0.198 2.177,0.198 false 0.177,1.521 0.375,1.74 0.198,0.219 10 false *a 2.177,0.083 2.375,0.302 0.198,0.219 10 false *1 0.396,2.604 0.833,2.771 0.438,0.167 10 false AUTO 0.333,3.083 0.823,3.25 0.49,0.167 10 false DOWN 2.552,2.25 2.906,2.417 0.354,0.167 10 false GND 2.51,3.156 2.74,3.323 0.229,0.167 10 false UP 0.5,2.25 0.813,2.406 0.313,0.156 10 false LED

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
6 (UP) - 1(GND) Manual up operation Below 1 Ω
7 (DOWN) - 1 (GND) Manual down operation Below 1 Ω
8 (AUTO) - 1 (GND) Auto up/down operation Below 1 Ω
6 (UP) - 1 (GND) Not operated 10 kΩ or higher
7 (DOWN) - 1 (GND) Not operated 10 kΩ or higher
8 (AUTO) - 1 (GND) Not operated 10 kΩ or higher


If the result is not as specified, replace the rear power window regulator switch assembly.



b.

Check that the LED illuminates.

i.

Apply battery voltage to the power window regulator switch and check that the LED illuminates.

OK:
Measurement Condition Specified Condition
Battery positive (+) → 4 (LED)
Battery negative (-) → 1 (GND)
LED illuminates


If the result is not as specified, replace the rear power window regulator switch assembly.


Text in Illustration
*1 LED
*a Front view of wire harness connector
(Power Window Regulator Switch Assembly)