85720G
1.INSPECT REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
Check that the motor gear rotates smoothly as follows.
Do not apply positive (+) battery voltage to any terminals except terminal 2 (B) to avoid damaging the pulse sensor inside the motor.
| Measurement Condition | Specified Condition |
|---|---|
1.
Connect the positive (+) battery terminal to terminal 2 (B), and connect the negative (-) battery cable to terminal 1 (GND), and keep them connected for 3 seconds or more. 2.
With terminals 2 (B) and 1 (GND) connected to the battery, connect the negative (-) battery terminal to terminal 10 (UP). 3.
Disconnect and reconnect the negative (-) battery terminal to terminal 10 (UP) within 1 second. |
Motor gear rotates clockwise (Up) |
1.
Connect the positive (+) battery terminal to terminal 2 (B), and connect the negative (-) battery terminal to terminal 1 (GND), and keep them connected for 3 seconds or more. 2.
With terminals 2 (B) and 1 (GND) connected to the battery, connect the negative (-) battery terminal to terminal 7 (DOWN). 3.
Disconnect and reconnect the negative (-) battery terminal to terminal 7 (DOWN) within 1 second. |
Motor gear rotates counterclockwise (Down) |
If the result is not as specified, replace the rear power window regulator motor assembly.
Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor and regulator assembly to the door.
| *a | Motor Gear |
| *b | Clockwise |
| *c | Counterclockwise |
85710F
2.INSPECT REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH
Check that the motor gear rotates smoothly as follows.
Do not apply positive (+) battery voltage to any terminals except terminal 2 (B) to avoid damaging the pulse sensor inside the motor.
| Measurement Condition | Specified Condition |
|---|---|
1.
Connect the positive (+) battery terminal to terminal 2 (B), and connect the negative (-) battery terminal to terminal 1 (GND), and keep them connected for 3 seconds or more. 2.
With terminals 2 (B) and 1 (GND) connected to the battery, connect the negative (-) battery terminal to terminal 10 (UP). 3.
Disconnect and reconnect the negative (-) battery terminal to terminal 10 (UP) within 1 second. |
Motor gear rotates counterclockwise (Up) |
1.
Connect the positive (+) battery terminal to terminal 2 (B), and connect the negative (-) battery terminal to terminal 1 (GND), and keep them connected for 3 seconds or more. 2.
With terminals 2 (B) and 1 (GND) connected to the battery, connect the negative (-) battery terminal to terminal 7 (DOWN). 3.
Disconnect and reconnect the negative (-) battery terminal to terminal 7 (DOWN) within 1 second. |
Motor gear rotates clockwise (Down) |
If the result is not as specified, replace the rear regulator motor assembly.
Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor and regulator assembly to the door.
| *a | Motor Gear |
| *b | Clockwise |
| *c | Counterclockwise |