Home › Vehicle Exterior › WINDOW / GLASS › BACK DOOR POWER WINDOW MOTOR
RM1440E _59 Vehicle Exterior _056166 WINDOW / GLASS _0274168 BACK DOOR POWER WINDOW MOTOR G

WINDOW / GLASS  BACK DOOR POWER WINDOW MOTOR  INSPECTION  


PROCEDURE

Hide 85720C 1.INSPECT BACK DOOR POWER WINDOW REGULATOR MOTOR ASSEMBLY

a.
B239026E05
1.719,1.094 1.406,0.219 1.406,0.219 1.313,0.219 true 1.063,2.917 1.635,3.146 false 1.896,3.156 2.417,3.031 false 1.573,3.5 1.156,3.646 false 1.958,3.49 2.406,3.646 false 1.125,0.125 1.333,0.313 0.208,0.188 10 false *a 2.208,1.802 2.448,1.99 0.24,0.188 10 false *b 0.917,2.813 1.281,3 0.365,0.188 10 false B 2.458,2.927 2.823,3.115 0.365,0.188 10 false GND 0.906,3.635 1.271,3.823 0.365,0.188 10 false UP 2.458,3.635 2.958,3.823 0.5,0.188 10 false DOWN 2.969,0.927 3.177,1.281 0.208,0.354 10 false *c

Check that the motor gear rotates smoothly as follows.

NOTICE:

Do not apply positive (+) battery voltage to any terminals except terminal 2 (B) to avoid damaging the pulse sensor inside the motor.


OK:
Measurement Condition Specified Condition
1.

Connect the positive (+) battery terminal to terminal 2 (B), and connect the negative (-) battery terminal to terminal 1 (GND), and keep them connected for 3 seconds or more.

2.

With terminals 2 (B) and 1 (GND) connected to the battery, connect the negative (-) battery terminal to terminal 10 (UP).

3.

Disconnect and reconnect the negative (-) battery terminal to terminal 10 (UP) within 1 second.


Motor gear rotates clockwise (Up)
1.

Connect the positive (+) battery terminal to terminal 2 (B), and connect the negative (-) battery terminal to terminal 1 (GND), and keep them connected for 3 seconds or more.

2.

With terminals 2 (B) and 1 (GND) connected to the battery, connect the negative (-) battery terminal to terminal 7 (DOWN).

3.

Disconnect and reconnect the negative (-) battery terminal to terminal 7 (DOWN) within 1 second.


Motor gear rotates counterclockwise (Down)


If the result is not as specified, replace the front power window regulator motor assembly.


CAUTION:

Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor and regulator assembly to the door.


Text in Illustration
*a Motor Gear
*b Clockwise
*c Counterclockwise