Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF HOUSING
RM1440E _59 Vehicle Exterior _056167 SLIDING ROOF / CONVERTIBLE _0274175 SLIDING ROOF HOUSING A

SLIDING ROOF / CONVERTIBLE  SLIDING ROOF HOUSING  DISASSEMBLY  


PROCEDURE

Hide 63260A 1.REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY

a.
B234372

Detach the bracket claw and remove the bracket.


b.

Remove the 2 bolts and drive gear.


Hide 63306 2.REMOVE SUNSHADE TRIM SUB-ASSEMBLY

B234373E01
3.441,1.498 4.135,1.801 0.693,0.304 10 *a

Text in Illustration
*a Rearward - -

a.

Remove the 2 screws.


b.

Detach the 4 claws and remove the sliding roof piece LH and RH.


c.

Slide and remove the trim.


Hide 63229A 3.REMOVE SLIDING ROOF SUNSHADE STOPPER LH

a.
B178631

Remove the stopper.


Hide 63229A 4.REMOVE SLIDING ROOF SUNSHADE STOPPER RH

HINT:

Use the same procedures described for the LH side.


Hide 63205A 5.REMOVE SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

NOTICE:

Do not disassemble the sliding roof drive cable sub-assembly except when replacing it.


a.

Remove the 2 screws and 2 stoppers.

B234374


b.
B234375E02
1.552,1.156 1.146,0.948 1.146,0.948 0.938,0.948 false 1.406,3.052 1.76,3.375 0.354,0.323 10 false *a 0.75,0.854 0.948,1.115 0.198,0.26 10 false *1 1.344,3.281 1.552,3.479 0.208,0.198 10 false *a

Using a screwdriver, detach the 2 claws and slide the rear roof drip channel rearward to remove it.

Text in Illustration
*1 Protective Tape
*a Rearward

HINT:

Tape the screwdriver tip before use.



c.
B234376

Hold down the window deflector.


d.
B234377E02
1.135,0.271 1.458,0.271 1.458,0.271 2.292,0.792 false 2.281,0.979 1.208,0.979 false 0.969,0.198 1.156,0.448 0.188,0.25 10 false *1 1.01,0.906 1.198,1.156 0.188,0.25 10 false *2

Place matchmarks on the sliding roof drive cable sub-assembly at locations A and B as shown in the illustration.

Text in Illustration
*1 Matchmark A
*2 Matchmark B


e.
B234378E01
1.134,0.154 1.360,0.338 0.225,0.184 10 *1 2.002,1.452 1.765,0.257 1.765,0.257 1.358,0.257 false

Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to remove it.

Text in Illustration
*1 Protective Tape
V100135

Slide

HINT:

Tape the screwdriver tip before use.