Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF HOUSING
RM1440E _59 Vehicle Exterior _056167 SLIDING ROOF / CONVERTIBLE _0274175 SLIDING ROOF HOUSING A

SLIDING ROOF / CONVERTIBLE  SLIDING ROOF HOUSING  REASSEMBLY  


PROCEDURE

Hide 63205A 1.INSTALL SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

a.
B234379

Hold down the window deflector.

NOTICE:

Make sure that the spring indicated by the arrow in the illustration is securely installed.



b.
B234380E01
1.564,0.747 1.824,0.949 0.260,0.202 10 *1 1.767,0.844 2.163,0.844 2.163,0.844 2.879,1.314 false

Using a screwdriver, slide the drive cable in the direction indicated by the arrow in the illustration to install it.

HINT:

Tape the screwdriver tip before use.


Text in Illustration
*1 Protective Tape
V100135

Slide


c.
B234381E02
1.344,3.333 1.625,3.635 0.281,0.302 10 false *a

Slide the rear roof drip channel forward and attach the 2 claws to install it.

Text in Illustration
*a Forward


d.

Install the 2 stoppers with the 2 screws.

B234374


Hide 63205A 2.ADJUST SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

B234382E03
1.151,0.132 1.367,0.311 0.216,0.180 10 *1 1.151,0.515 1.363,0.695 0.212,0.180 10 *2 1.091,0.922 1.334,1.104 0.243,0.183 10 *3 2.31,0.816 1.594,0.192 1.594,0.192 1.394,0.192 false 1.387,0.586 1.642,0.586 1.642,0.586 2.286,0.975 false 0.569,2.914 0.569,1.015 0.569,1.015 1.06,1.015 false

a.

Using a screwdriver, align the matchmarks by sliding the drive cable in the directions indicated by the arrow in the illustration.

HINT:

Tape the screwdriver tip before use.


Text in Illustration
*1 Matchmark A
*2 Matchmark B
*3 Protective Tape


Hide 63229A 3.INSTALL SLIDING ROOF SUNSHADE STOPPER LH

a.
B178631

Install the stopper.


Hide 63229A 4.INSTALL SLIDING ROOF SUNSHADE STOPPER RH

HINT:

Use the same procedures described for the LH side.


Hide 63306 5.INSTALL SUNSHADE TRIM SUB-ASSEMBLY

a.

Insert the sunshade trim into the sliding roof housing.

B234383E01
3.354,1.645 3.985,1.867 0.631,0.222 10 *a

Text in Illustration
*a Forward - -


b.

Attach the 4 claws to install the sliding roof piece LH and RH.


c.

Install the 2 screws.


Hide 63260A 6.INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY

a.

Install the drive gear with the 2 bolts.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)


b.
B234372

Attach the bracket claw to install the bracket.