Home › Vehicle Exterior › DOOR / HATCH › HOOD SUPPORT › from 2013.08
RM1440E _59 Vehicle Exterior _056168 DOOR / HATCH _0274176 HOOD SUPPORT A

DOOR / HATCH  HOOD SUPPORT  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 53482 1.INSTALL HOOD SUPPORT BRACKET LH

a.
B237110E03
2.521,1.542 2.76,1.688 0.24,0.146 10 true (1) 2.313,1.323 2.521,1.531 0.208,0.208 10 true (2)

Install the hood support bracket with the 2 bolts in the order shown in the illustration.

Torque:
18 N*m (178 kgf*cm, 13 ft.*lbf)


Hide 53450A 2.INSTALL HOOD SUPPORT ASSEMBLY LH

NOTICE:
·

Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing the vehicle.

·

Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.

·

In order to prevent the piston rod from deforming, do not apply any horizontal load to the door stay.



a.
B242389

Install a new hood support assembly.

NOTICE:

Install a new hood support assembly while supporting the hood by hand.



b.

Check that the hood support assembly is attached to the ball joint and it cannot be pulled out.