Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR
RM1440E _59 Vehicle Exterior _056168 DOOR / HATCH _0274180 BACK DOOR N

DOOR / HATCH  BACK DOOR  ADJUSTMENT  


CAUTION / NOTICE / HINT

HINT:
·
B216808E02
0.281,1.771 1.542,1.948 1.26,0.177 10 Centering Bolt 2.042,1.792 3.292,1.969 1.25,0.177 10 Standard Bolt

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.

·

Centering bolts are used to mount the door hinge to the vehicle body and door. The door cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts and washers when making adjustments.

·

The specified torque for standard bolts is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 1.INSPECT BACK DOOR

a.

Check that the clearance measurements of areas A through G are within each standard range.

B237265E01
2.977,0.265 3.217,0.476 0.241,0.211 10 A 3.272,0.488 3.513,0.699 0.241,0.211 10 B 5.818,0.644 6.059,0.855 0.241,0.211 10 C 6.119,2.146 6.360,2.357 0.241,0.211 10 D 1.415,2.036 1.655,2.247 0.241,0.211 10 E 1.345,3.537 1.586,3.748 0.241,0.211 10 F 3.822,3.751 4.062,3.962 0.241,0.211 10 G

Standard:
Area Measurement Area Measurement
A 9.2 to 12.2 mm (0.362 to 0.480 in.) B 0.0 to 3.0 mm (0.0 to 0.118 in.)
C 3.0 to 6.0 mm (0.118 to 0.236 in.) D 3.7 to 6.7 mm (0.146 to 0.264 in.)
E 6.25 to 9.25 mm (0.246 to 0.364 in.) F 6.55 to 9.55 mm (0.258 to 0.376 in.)
G 8.45 to 11.45 mm (0.333 to 0.451 in.) - -



Hide 2.ADJUST BACK DOOR

a.
B237266

Before adjusting the upper end of the back door up and down or left and right, loosen the bolts.


b.

Tighten the body side hinge after the adjustment.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


c.
B237267

Using a T40 "TORX" socket wrench, slightly loosen the striker mounting screws.


d.

Using a brass bar and hammer, hit the striker to adjust its position.


e.

Using a T40 "TORX" socket wrench, tighten the striker mounting screws after the adjustment.

Torque:
27 N*m (275 kgf*cm, 20 ft.*lbf)