84840G
1.INSPECT BACK DOOR OPENER SWITCH ASSEMBLY
Check the operation of the opener switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Position | Specified Condition |
|---|---|---|
| 1 (UL) - 2 (E) | Back door opener switch assembly (opener switch) not pushed (off) | 10 kΩ or higher |
| 1 (UL) - 2 (E) | Back door opener switch assembly (opener switch) pushed (on) | Below 1 Ω |
If the result is not specified, replace the back door opener switch assembly.
| *a | Component without harness connected
(Back Door Opener Switch Assembly) |