Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR SUPPORT
RM1440E _59 Vehicle Exterior _056168 DOOR / HATCH _0274182 BACK DOOR SUPPORT A

DOOR / HATCH  BACK DOOR SUPPORT  INSTALLATION  


PROCEDURE

Hide 68946 1.INSTALL BACK DOOR UPPER DAMPER STAY BRACKET LH

a.
B240239E02
2.26,0.854 2.552,1.073 0.292,0.219 10 true (1) 2,1.594 2.219,1.813 0.219,0.219 10 true (2)

Install the back door upper damper stay bracket with the 2 bolts.

HINT:

Tighten the bolts in the order shown in the illustration.


Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


Hide 68961 2.INSTALL BACK DOOR STAY BOLT

a.

Clean the threaded portion on the vehicle body with a non-residue solvent.


b.

Apply adhesive to the threads of the bolt.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



c.
B240247

Install the back door stay bolt.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)


Hide 68908 3.INSTALL BACK DOOR DAMPER STAY SUB-ASSEMBLY LH

NOTICE:
·

Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing the vehicle.

·

Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.

·

In order to prevent the piston rod from deforming, do not apply any horizontal load to the door damper stay.



a.
B240240

Install the back door damper stay sub-assembly.

NOTICE:
·

Install the back door damper stay sub-assembly while supporting the back door by hand.

·

Check that the back door stay assembly is attached to the ball joint and that the back door damper stay sub-assembly cannot be pulled out.