Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR SUPPORT
RM1440E _59 Vehicle Exterior _056168 DOOR / HATCH _0274182 BACK DOOR SUPPORT A

DOOR / HATCH  BACK DOOR SUPPORT  REMOVAL  


PROCEDURE

Hide 68908 1.REMOVE BACK DOOR DAMPER STAY SUB-ASSEMBLY LH

NOTICE:
·

Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing the vehicle.

·

Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.

·

In order to prevent the piston rod from deforming, do not apply any horizontal load to the door damper stay.



a.
B242503E03
0.896,1.396 0.833,1.396 0.833,1.396 0.75,1.458 true 2.719,0.167 2.667,0.167 2.667,0.167 2.469,0.396 true 0.906,1.302 1.135,1.521 0.229,0.219 10 true *1 2.729,0.073 2.958,0.292 0.229,0.219 10 true *1

Using a screwdriver, remove the stop ring along the groove.

HINT:

Tape the screwdriver tip before use.


Text in Illustration
*1 Protective Tape


b.

Release the ball joint and remove the back door damper stay sub-assembly.

NOTICE:

Remove the back door damper stay sub-assembly while supporting the back door by hand.



Hide 68961 2.REMOVE BACK DOOR STAY BOLT

a.
B240247

Remove the back door stay bolt.

NOTICE:

If the hood support is detached from the ball joint, it becomes non-reusable. Therefore, do not detach the hood support from the ball joint unless replacing it.



Hide 68946 3.REMOVE BACK DOOR UPPER DAMPER STAY BRACKET LH

a.
B240239

Remove the 2 bolts and back door upper damper stay bracket.