Home › Vehicle Exterior › DOOR / HATCH › HOOD › 2009.08–2013.08
RM1440E _59 Vehicle Exterior _056168 DOOR / HATCH _0274183 HOOD N

DOOR / HATCH  HOOD  ADJUSTMENT  


CAUTION / NOTICE / HINT

B246460E01
0.182,0 1.394,0.239 1.211,0.239 12 Centerring Bolt 1.995,0 3.082,0.239 1.086,0.239 12 Standard Bolt

HINT:
·

Centering bolts are used to mount the hood hinge and hood lock. The hood and hood lock cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts when making adjustments.

·

The specified torque for standard bolts is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 53381 1.REMOVE HOOD TO RADIATOR SUPPORT SEAL

Hide 53115B 3.REMOVE RADIATOR GRILLE BRACKET

Hide 5.ADJUST HOOD SUB-ASSEMBLY

a.

Adjust the hood position.

i.
B237105

Loosen the 4 hinge bolts on the hood.


ii.

Move the hood and adjust the clearance between the hood and front fender.


iii.

Tighten the 4 hinge bolts on the hood after the adjustment.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)



b.

Adjust the height of the front end of the hood using the cushion rubbers.

i.
B237106

Adjust the cushion rubbers so that the hood and fender are aligned.

HINT:

Raise or lower the front end of the hood by turning the 2 cushion rubbers.




c.

Adjust the hood lock.

i.
B237107

Loosen the 3 bolts.


ii.

Adjust the hood lock and tighten the 3 bolts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


iii.

Check that the striker can engage with the hood lock smoothly.



Hide 53381 8.INSTALL HOOD TO RADIATOR SUPPORT SEAL