87961
1.REMOVE OUTER MIRROR LH
87945
2.REMOVE OUTER MIRROR COVER LH
Remove the tape.
| *1 | Tape |
Put protective tape around the lower mirror cover.
Using a screwdriver, detach the 6 claws and remove the lower mirror cover.
Tape the screwdriver tip before use.
Apply protective tape to the mirror body
| *1 | Protective Tape |
Using a T25 "TORX" socket wrench, remove the 3 screws.
Using a T25 "TORX" socket wrench, remove the screw.
Detach the claw and remove the 3 screws.
Pull out the mirror actuator in order to detach the claws blocked by the mirror actuator shown in the parts of the illustration labeled 1, 2, 3 and 6.
Be sure not to pull out the mirror actuator too far.
Using a screwdriver, detach the 8 claws in the order shown in the illustration and remove the mirror cover.
When removing the cover, be careful not to damage the side turn signal light or cover.
| *1 | Mirror Actuator |
81740
3.REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY LH